Set this flag to true if local position is valid but accuracy low, such that
the operator can be warned before system switches to position-failure failsafe.
Additionally, switch to RTL if currently in Mission or Loiter to try to reach home
or fly out of GNSS-denied area.
Set low accuracy threshold to 50m by default for FW and VTOL.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- use `gazebo-classic` everywhere consistently referring to the original Gazebo (eg version 9,10,11)
- additional `gazebo_*` helper targets added for compatibility, but warn about deprecation and tell you the new target naming
- use `gz` everywhere when referring to Gazebo (aka Ignition Gazebo or new Gazebo)
* Fixedwing rate control into a separate module
* Start fw_rate_control for vtol
* Move over airspeed related parameters to fw_rate_control
Co-authored-by: Silvan Fuhrer <silvan@auterion.com>
Multiple agents can connect to the same client
For sitl builds, if the intance number is different from zero,
XRCE_DDS_KEY is set to the instance number and
the microdds_client is automatically started
with namespace
px4_"instance_number"
and udp port 8888
If the instance number is equal to zero
XRCE_DDS_KEY is left untouched and
the microdds_client is automatically started
without namespace
and udp port 8888
Signed-off-by: Beniamino Pozzan <beniamino.pozzan@phd.unipd.it>
The partecipant name is modified into
"client_namespace"/px4_micro_xrce_dds
For sitl builds the microdds_client is automatically started
with namespace
px4_"instance_number"
and udp port
8888+"intance_number"
Signed-off-by: Beniamino Pozzan <beniamino.pozzan@phd.unipd.it>
Add ARK_FMU_V6X to RCS netman
Remove arkv6x rc single wire
Fix arkv6x mtd
arkv6x bootloader init all pins to prevent power cycling peripherals on boot
arkv6x don't power cycle sd card on boot
arkv6x add UART4 Telem 4
landing airspeed was previously defined by a scale factor multiplied by minimum airspeed. this commit changes this parameter to an explicit speed, and when unspecified, defaults to the minimum airspeed
MIS_LTRMIN_ALt was used to limit the go-to altitude of a LOITER_TO_ALT (not the exit altitude,
but the altitude that the vehicle went to to fly to WP), and during landing abort to climb to
at least this altitude. The min entry altitude of LOITER_TO_ALT I remove with this commit, while
for the min alt during abort I added the new parameter MIS_LND_ABRT_ALT.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Replace the existing check for the availability of a takeoff mission item with a combined
check for takeoff and landing item (or landing pattern). New param MIS_TKO_LAND_REQ
can be set to require only a takeoff, only a landing, both takeoff and landing, and
both or none. The latter is meant to be set if is e.g. deemed unsafe to start a flight
through a Takeoff WP without though defining a Landing - as then in case of a RTL the
vehicle doesn't follow a pre-defined path but instead only can do default RTL that especially
for FW and VTOL isn't always safe.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
