According to the mavlink spec we should be publishing the home attitude
as a quaternion rather than just the yaw/heading.
Additionally, this allows setting the landing roll and pitch angle using
DO_SET_HOME (this yet needs to go into the MAVLink spec though).
This time including the message versioning and translation.
* Remove Zubax Orel - not available and no other presence
* Fix up zubax product links
* Snapdragon flight - delete as no longer relevant hardware
* Delete intel aero docs
* Brushless whoop - remove docs except for link to old version
* Many link fixes
Previously, when switching from a goto setpoint into a mode that publishes
trajectory_setpoint, the previous goto setpoint was still used for 500ms,
which then caused a setpoint jump.
This change makes sure that when a trajectory_setpoint is received, any
existing goto setpoint is marked as invalid immediately.
There was a race condition: for example when an external mode disabled
failsafe deferring, that then triggered a failsafe, while the mode executor
immediately sends a command (to e.g. switch modes).
In that case the failsafe got triggered but the mode switch was still
allowed.
This was because of the processing ordering:
- mode updates (and propagating the failsafe_action_active state)
- failsafe updates
- command handling
This patch makes sure failsafe_action_active is set immediately after
updating the failsafes.
Previously, when deferring was active and e.g. RC loss was triggered, and
RC regained, the action was not cleared, as the RC loss action only clears
on mode switch/disarm (when set to RTL for example).
When deferring was then disabled, the RC loss failsafe would still trigger.
This changes the behavior to immediately remove those actions when
deferring is active.
It also ensures to reset the Hold delay when deferring is disabled and no
failsafe is being deferred.
* Doc Orbit: update and clarify configurability and behavior around limits
* run prettier
* Fix up link to table
---------
Co-authored-by: Hamish Willee <hamishwillee@gmail.com>
dshot: fix motor test on CANnode
Also includes fixes for the DShot driver since stop_outputs is removed. The esc info command has been removed because it doesn't work with AM32, can only be used via command line, and complicates the driver
Hamish Willee