The voxl2 has a split architecture. PX4 runs on a posix platform and a Qurt platform. The two communicate uorb topics back and forth with the muorb module. But each has it's own parameters database and they need to stay in sync with each other. This PR adds support to keep the 2 parameter databases in sync. The main parameters database running on Linux has file system support while the Qurt one does not. The Linux side is considered the primary and the Qurt side is considered the remote.
Previously uORB queue size was an awkward mix of runtime configurable (at advertise or IOCTL before allocate), but effectively static with all queue size settings (outside of test code) actually coming from the topic declaration (presently ORB_QUEUE_LENGTH in the .msg). This change finally resolves the inconsistency making the queue size fully static.
Additionally there were some corner cases that the muorb and orb communicator implementation were not correctly handling. This PR provides fixes for those issues. Also correctly sets remote queue lengths now based on the topic definitions.
* Made setting of uORB topic queue size in based on topic definition only
* Fixes to the ModalAI muorb implementation
* Removed libfc sensor from format checks
* msg/TransponderReport.msg ORB_QUEUE_LENGTH 8->16 (was set to higher in AdsbConflict.h
---------
Co-authored-by: Eric Katzfey <eric.katzfey@modalai.com>
Co-authored-by: Daniel Agar <daniel@agar.ca>
* battery: make time remaining estimation dependent on level flight characteristis for FW
* battery: fix that FW flight is also correctly detected when vehicle_status is not updated
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
* FixedwingPositionControl: Move constant to header file
* flight phase estimation: use tecs height rate reference to check for level flight
---------
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Co-authored-by: Silvan Fuhrer <silvan@auterion.com>
* PositionSetpoint: remove yaw_valid field
* Navigator: set yaw setpoint to NAN for Takeoff
Don't set a yaw setpoint for takeoff, as Navigator doesn't handle the yaw reset.
The yaw setpoint generation is handled by FlightTaskAuto.
* PositionSetpoint.msg: remove disable_weather_vane and instead only use the yaw field
Strictly follow the concept that if the position_setpoint.yaw is set, then
follow it the controller, and otherwise let the controller set it as it
thinks it's best.
* Navigator: remove logic that sets yaw to be accepted in TAKEOFF
No longer needed as during Takeoff we anyway don't set a yaw setpoint.
* PositionSetpoint.msg: remove yawspeed_valid
* PositionSetpoint.msg: remove yawspeed
* Navigator: set yaw setpoint to NAN instead of current
In set_takeoff and set_land_item, as well as for VTOL transition.
The flight tasks then set the yaw corresponding to the current yaw.
* Navigator: change get_yaw_acceptance into a bool
* PositionSetpoint.msg: improve comment for yaw
* MissionBlock: remove unnecessary code from set_vtol_transition_item
* Navigator: clean up calculate_breaking_stop(), set yaw to NAN
* Navigator: set yaw to NAN in variouls places where not specifc setpoint is desired
* Navigator: set yaw to NAN in reset_position_setpoint()
---------
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Co-authored-by: Matthias Grob <maetugr@gmail.com>
