As the sensor can directly report the amount of samples in the fifo, use it to simplify the logic.
Also combine the fifo empty/fifo overflow checks for interrupt and polling modes.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
If DRDY signal is used, the interrupt status needs to be cleared at FIFO reset
in order to make DRDY go back inactive. Otherwise there won't be a falling edge
interrupt at the next sample.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
* Fix: replay the mission cached items only upon reaching resume waypoint
* Refactoring
Split camera mode mission items from gimbal ones so to have a finer control over the relative replays
* Chore: fix formatting
---------
Co-authored-by: Silvan Fuhrer <silvan@auterion.com>
* Remove euler angles from attitude setpoint message
* Remove usage of euler angles in attitude setpoint messages
This commit removes the usage of euler angles in the vehicle_attitude_setpoint messages
* Fix standard vtol
This adds explicit handling for the few things we want to allow through a MAVLink instance dedicated to a gimbal/(camera) payload as per the MAVLink gimbal mode configuration.
- the module documentation parser can only resolve defines from the same file
- also it cannot deal with defines embeded in strings
- what board should it add for the general documentation anyways?
As a result of these issues I suggest to stay with the original hardcoded
/fs/microsd for the documentation. It's still the most common path as far as
I can see.
We've come accross a case where a ROS node would consistently take something
over 800 ms until the first arming check request subscription callback was
triggered.
After the first sample, the callback always triggered within the expected
timeframe.
Therefore this patch allows for more time right after registration until
timing out.
* Update Zenoh-pico from 0.7.0 to 1.0.0
* Update the zenoh-pico version to use PX4/dev/1.0.0-px4
* Remove the rostopic and rt/ prefix
* Unlike zenoh-bridge-dds we were using, zenoh-bridge-ros2dds is now adding the rt/ prefix automagically.
Avoid flying into terrain using the distance sensor.
Enable through the parameter NAV_MIN_GND_DIST.
Only active during commanded descents with vz>0 (to prevent climb-aways),
excluding landing and VTOL transitions.
It changes the altitude setpoint in the triplet to maintain the current altitude
and republish the triplet. We also change the mission item altitude used for
acceptance calculations to prevent getting stuck in a loop.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
murata,katsutoshi