make sure that the relative altitude of the takeoff waypoint is
at least one meter higher than the acceptance radius of the waypoint.
This makes sure that the takeoff waypoint is not reached before the vehicle
is at least one meter in the air.
Added missing functions that were added for other targets but not for qurt.
Added workaround for missing sem_timedwait(). This may have a performance
impact until a sem_timedwait is supported.
std::to_string is not supported by the hexagon compiler
Signed-off-by: Mark Charlebois <charlebm@gmail.com>
The mavlink stream from the simulator and the mavlink stream over serial
(used for RC input) both had the same MAVLINK_COMM channel and were
therefore sharing an internal buffer in mavlink_parse_char. This meant
that most (low rate) serial messages were getting swallowed by the high
rate simulator stream.
This change fixes the issue where RC input was not properly arriving in
Gazebo, however it breaks the `commander takeoff` command in SITL which
needs to be investigated.
* PX4/master: (45 commits)
don't use default source address for onboard udp link, wait on remote
Configure Easystar HIL setup to do Runway takeoff
ROMFS: Set 3DR quad tuning to more realistic default values
Fix incomplete boot on new EKF config
Fix px4fmu-v2_ekf2 config
Updated MAVLink protocol version
MAVLink: Start slightly differently on USB
Start shell only if SD card not present
Update ECL
NuttX configs: added px4fmu-v2_ekf2 target for EKF2 development on Pixhawk
Get QuRT drivers out of the way, as we are using our own
Fix POSIX eagle config
Remove unmaintained NuttX config
VDev: fix code style
Add new posix_eagle_default and qurt_eagle_default targets
Fix QuRT build error
Fix FMUv4 USB PID
Speed up Vagrant
VTOL: Fix motor index use in VT_FW_MOT_OFF. Create new param to re-default all deployed vehicles to not shut down motors.
VTOL: Fix MOT_OFF bug
...
