New thrust and torque control mode added which replaces the previous
actuator mode,
in this mode the rate controllers are disables, the control allocator
is enabled and the used externally provices
vehicle_thrust_setpoints and vehicle_torque_setpoints.
New direct_actuator mode
In direct_actuator mode the control allocator module does not publish
actuator_motors and actuator_servos messages which must instead be
provided extrernally by the user.
Removed old direct mode.
Signed-off-by: Beniamino Pozzan <beniamino.pozzan@gmail.com>
- do reporting of breaching in-air only in geofenceCheck
- remove geofence_violation_reason_t
- replace geofence_breached field in GeofenceResult.msg with 3 fields
(one for each GF type: max dist, max alt, custom geofence)
- the warning message after breaching a GF is only done by Commander,
and it's specific to the GF type failure
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Has options *None where the check is disabled, and *Warning, where only a warning is
published (which replaces the high wind warning from the COM_WIND_WARN limit).
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Some system are able to dead-reckon for a while after losing GPS or
other sources providing positional feedback. If the estimated position
error grows above the failsafe threshold, the system enters a failsafe
mode. As the position error estimate is growing linerly over time, and
it is recommended to take action before entering the failsafe, we here
warn the user about the imminent failsafe and propose to take manual
control.
---------
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Since we changed the threshold for allowing arming from TRIM/2 to AIRSPEED_MAX
is is very unlikely that one needs to disable this check.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
COM_ARMABLE is set to "Disabled" will prevent arming.
This allows to set the parameter when ground demoing a drone or
if it's in maintenance for safety reasons.
Set this flag to true if local position is valid but accuracy low, such that
the operator can be warned before system switches to position-failure failsafe.
Additionally, switch to RTL if currently in Mission or Loiter to try to reach home
or fly out of GNSS-denied area.
Set low accuracy threshold to 50m by default for FW and VTOL.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
In this case it did not cause any problems.
Fixes a compiler warning:
/src/modules/commander/HealthAndArmingChecks/HealthAndArmingChecks.cpp:39:21: error: member ‘HealthAndArmingChecks::_failsafe_flags’ is used uninitialized [-Werror=uninitialized]
39 | _reporter(_failsafe_flags)
| ^~~~~~~~~~~~~~~
- avoid the possibility of unsigned underflow from subtracting two HRT timestamps (uint64_t)
- most of these aren't problematic, but people tend to replicate the pattern, so it's better to be safe
- likely wasn't a problem when people were using hrt_absolute_time() in place, but if using an existing timestamp there's the possibility it's older than a more recent topic update
Silvan Fuhrer