- track and publish validity based on hover thrust variance, innovation test ratio, and hysteresis
- only publish on actual updates or becoming inactive
- fix dt (previous timestamp wasn't being saved)
- use local position timestamp (corresponding) to accel data rather than current time to avoid unnecessary timing jitter
- check local position validity before using
- mc_hover_thrust_estimator: move from wq:lp_default -> wq:nav_and_controllers to ensure the hover thrust estimator runs after the position controller and uses the same vehicle_local_position data
- land_detector: check hover thrust estimate validity and adjust low throttle thresholds if hover thrust is available
- mc_pos_control: only use hover thrust estimate if valid
- always check system field for validity
- reject any data outside of "servo position" valid range from Spektrum specification
- properly support XPlus channels (12+)
- debug message if channel count changes
For the RC controlled yaw behaviour, we do a yaw setpoint according to
the stick expo. The uncontrolled yaw behaviour behaves undefined.
Switching between yaw behaviours makes the drone stand still for a
moment, which probably can be improved.
This Commit includes a update of the mavlink submodule
since the CELLULAR_STATUS message was updated, the necessary changes were done together
Add enums
- remove all remaining IOCTLs for accel and gyro and handle all calibration entirely in sensors module with parameters
- sensor_accel and sensor_gyro are now always raw sensor data
- calibration procedures no longer need to first clear existing values before starting
- temperature calibration (TC) remove all scale (SCL) parameters
- gyro and baro scale are completely unused
- regular accel calibration scale can be used (CAL_ACC*_xSCALE) instead of TC scale
- IMU integration move from drivers (PX4Accelerometer/PX4Gyroscope) to sensors/vehicle_imu
- sensors: voted_sensors_update now consumes vehicle_imu
- delete sensor_accel_integrated, sensor_gyro_integrated
- merge sensor_accel_status/sensor_gyro_status into vehicle_imu_status
- sensors status output minor improvements (ordering, whitespace, show selected sensor device id and instance)
This moves the handling of the BAT%d_SOURCE param inside of the battery
library. Users of the library now pass the source instead of the flag
whether to publish. The battery library then checks if the source is
selected using the param and publishes accordingly.
Since we removed the strange system_source flag, we now need to look at
all batteries in commander.
For current estimation - I think - it makes sense to sum them up.
* Enhancement: State of health, and max_error value is added. Both shows battery health of SMBUS smart battery.
* Enhancement: BAT_C_MULT parameter is introduced. This is for high-current capable SMBUS-based battery.
As SMBUS only provides 16-bit for current, it could only be +-32768mA which is about +-32A.
But with proper treatment, it could be extended with little accuracy loss.
This factor can be set for individual battery system with available information.
* Relative SOC introduced. Proper SMBUS battery should provide percentage of remaining battery
directly. Therefore it does not have to be computed like before.
* State of Health introduced. Proper SMBUS battery should provide SOH value.
* Max error: this shows estimation error of BMS.
* Enhancement: With smart battery, precise estimation of time remaining is provided
with impedance track. It is unit of minute, so 60 seconds multiplied.
Update rate of this is not fast, but very useful.
Co-authored-by: Hyon Lim <lim@uvify.com>
