I don't think we have a way to explicitly detect if BAT1 or BAT2
"bricks" are correct, so we have to assume they are, and rely on the
voltage/current shown.
Additionally, we can now power cycle sensor power.
It turns out that we set the ADC range incorrectly leading to the
measured current being capped at a certain level as the ADC on the
sensor saturates.
Instead, we need to set the range according to the formula given in the
interface datasheet.
* hrt: Fix PPM input on channel 2
The CCMR1_PPM define for PPM input on channel 2 was incorrectly set to 2,
which was setting bits for channel 1 instead of channel 2. This prevented
PPM input from functioning properly on channel 2.
Changed CCMR1_PPM for channel 2 from 2 to (1 << 8), which correctly
configures the CC2S bits for input capture mode on TI2.
This fixes an issue noted in the existing code comment:
"FIXME! There is an interaction in the CCMR registers that prevents
using Chan 1 as the timer and chan 2 as the PPM"
Tested on STM32H743 with PPM input on PC7 (TIM8_CH2).
* rc_input: enable sharing serial and PPM pin
By setting RC_SERIAL_PORT_SHARED_PPM_PIN_GPIO_RX it is now possible to
use the same pin on the STM32 for PPM input as well as serial input.
* boards: Add support for Holybro KakuteH7-Wing
---------
Co-authored-by: Julian Oes <julian@oes.ch>
* Rescale throttle curve to HTE as option
* Add slew rate to hover thrust estimate
* Update docs to reflect changes
Fix formating
* mc_att_control: suggestions for hover thrust slewing
- Slower slew rate
- Move update of hover thrust estimate into main loop
- Make sure dt for slew rate is correct
- Apply parameter updates if hover thrust estimate not used
- Parameter description in metadata files
* fix: Rescaling cases order
* Rescale to HTE estimate by default
* Update src/modules/mc_pos_control/multicopter_position_control_params.c
Co-authored-by: Mathieu Bresciani <brescianimathieu@gmail.com>
* Fix hte sub name
* Update MPC_THR_CURVE description
* Swap thr curve values to make hte rescaling default for value 0
---------
Co-authored-by: Matthias Grob <maetugr@gmail.com>
Co-authored-by: Mathieu Bresciani <brescianimathieu@gmail.com>
Matthias Grob