* commander: send parachute command on termination
This sends the DO_PARACHUTE command to parachute component.
* commander: fix lying comments and printf
* commander: use one flag for termination triggered
This merges the duplicate flags _flight_termination_triggered and
_flight_flight_termination_printed.
* commander: correct variable name
* commander: always send tune with parachute
* commander: fix target_component for parachute cmd
The previous changes were wrong in that all commands were now sent to
the parachute component which doesn't make any sense. Of course only the
parachute command should be sent there.
Instead of only keeping track of the sequence ID of specific "supported"
components, we now keep track of any sysid/compid of an incoming
message. Before this change, unknown components (such as jMAVSim) would
completely screw up the mavlink message stats and create confusion (at
least in my case).
With this change we currently keep track of up to 8 other components.
Once we reach the limit, we will print a warning.
statfs accesses the file-system and can be blocking for an extended period. Since the SD card check is part of the preflight checks in the main thread of commander, it could block its execution and cause various issues. The SD card is only mounted in rcS during boot so the state will not change after the first check.
- rotates accel & gyro FIFO data before publication both to simplify downstream usage (including log review) and fix other issues
- to best handle int16_t data rotations are now either performed with swaps if possible, otherwise promoted to float, rotated using the full rotation matrix, then rounded back to int16_t
- fix sensors/vehicle_angular_velocity filter reset both with proper rotation and new calibration uncorrect helper
- in FIFO case filtering is done before calibration is applied, but we need to handle a possible reset from a completely different sensor (vehicle body angular velocity -> sensor frame uncorrected data)
- fully respect datasheet quality and shutter metrics for mode changes
- use MOTION pin for scheduling if available
- log light mode
- refactor common enable LED code
- respect read and write time delays
