* feat: implement UAVCAN LED control for individual light control and assignment
* uavcan led: nit-picks from review
* uavcan led: reduce maximum number of lights
to avoid unused parameters
* uavcan led: simplify anticolision on check
* uavcan led: correctly map 8-bit RGB to rgb565
* Trim param name character arrays to 17
16 characters + \0 termination
* uavcan led: final nit-picks
---------
Co-authored-by: Matthias Grob <maetugr@gmail.com>
previous to this
09d79b221f
set `esc_online_flags` e.g. for UAVCAN ESCs which specific one is online and that then got compared to a mask where the first `esc_count` bits were set.
So if only ESC 5 is mapped and online you get the message "ESC 156 offline" because `esc_online_flags = 0b1000` gets compared to `online_bitmask = 0b1` based on `esc_count = 1` and the motor index is `esc[0].actuator_function = 0` wrapped using `0 - actuator_motors_s::ACTUATOR_FUNCTION_MOTOR1 + 1 = 156`.
The first test makes sure the user can take over when an RTL failsafe was triggered but degraded to a Land.
The second test rules out the easiest fix of removing the condition `_selected_action == selected_action` which causes the problem for test one but is there for a reason.
* added vehicle command and support to remotely activate/deactivate the safety system (#26078)
* added print_status support for prearm safety status
* updated safety button to map to MAV_CMD_DO_SET_SAFETY_SWITCH_STATE = '5300'
* safety switch cmd: fixed incorrect catch-all and added commanded_state variable for easier reading
When operating fully autonomously (i.e., without manual control or a guaranteed link to the ground station), tuning a vehicle can be difficult since the current autotune process requires either RC input or a GCS command. For these scenarios, it it useful to be able to start autotune inside a mission.
The mode executor can run land mode which updates the home position to the landing location. This
can be not the desirable behavior and the home position should stay at the original location.
A flag is added to the configuration overrides to control if the home position is updated or not.
Some modes should only be run within the context of a mode executor and the user should not be able
to select them in the GCS. With this change, the external component registration request can be
used to set if a mode is selectable or not.
* Changed the healthFailure call in the PowerChecks to ensure that no value above the low_error_threshold or below the high_error_threshold is reported in AMC
* fix format
* made _latest_low_failure and _latest_low_failure member variables. Only update them when hystersis state changes from false to true.
* rc_update: remove 1% deadzone for all channels
this should be handled higher level.
* Remove all references to the RC{n}_DZ parameters
Regular expression: RC.{0,2}_DZ
---------
Co-authored-by: Jacob Dahl <37091262+dakejahl@users.noreply.github.com>
ttechnick