* MulticopterPositionControl: Add timeout before triggering emergency setpoint on invalid TrajectorySetpoint
* Apply suggestions from code review
* Cleanup & address review comments
* Safegaurd against using old setpoint if states aren't valid anymore
---------
Co-authored-by: Jacob Dahl <37091262+dakejahl@users.noreply.github.com>
- Adds MSPv1 rx parsing to fetch VTX config
- Allows to inspect and change VTX channel through CLI
- Forward MSP_RC for stick commands osd
- Forward MSP_STATUS for arming status for PIT and LP mode
It turns out that we set the ADC range incorrectly leading to the
measured current being capped at a certain level as the ADC on the
sensor saturates.
Instead, we need to set the range according to the formula given in the
interface datasheet.
* hrt: Fix PPM input on channel 2
The CCMR1_PPM define for PPM input on channel 2 was incorrectly set to 2,
which was setting bits for channel 1 instead of channel 2. This prevented
PPM input from functioning properly on channel 2.
Changed CCMR1_PPM for channel 2 from 2 to (1 << 8), which correctly
configures the CC2S bits for input capture mode on TI2.
This fixes an issue noted in the existing code comment:
"FIXME! There is an interaction in the CCMR registers that prevents
using Chan 1 as the timer and chan 2 as the PPM"
Tested on STM32H743 with PPM input on PC7 (TIM8_CH2).
* rc_input: enable sharing serial and PPM pin
By setting RC_SERIAL_PORT_SHARED_PPM_PIN_GPIO_RX it is now possible to
use the same pin on the STM32 for PPM input as well as serial input.
* boards: Add support for Holybro KakuteH7-Wing
---------
Co-authored-by: Julian Oes <julian@oes.ch>
* Rescale throttle curve to HTE as option
* Add slew rate to hover thrust estimate
* Update docs to reflect changes
Fix formating
* mc_att_control: suggestions for hover thrust slewing
- Slower slew rate
- Move update of hover thrust estimate into main loop
- Make sure dt for slew rate is correct
- Apply parameter updates if hover thrust estimate not used
- Parameter description in metadata files
* fix: Rescaling cases order
* Rescale to HTE estimate by default
* Update src/modules/mc_pos_control/multicopter_position_control_params.c
Co-authored-by: Mathieu Bresciani <brescianimathieu@gmail.com>
* Fix hte sub name
* Update MPC_THR_CURVE description
* Swap thr curve values to make hte rescaling default for value 0
---------
Co-authored-by: Matthias Grob <maetugr@gmail.com>
Co-authored-by: Mathieu Bresciani <brescianimathieu@gmail.com>
The rotational speed threshold on fixed-wing vehicles is triggering easily
if the plane is lifted prior to takeoff (hand-launch), and can cause issues
for the auto takeoff state machine. Thus if either airspeed or groundspeed is valid,
it's better to rely on these for land detection, and only use the rotational
speed if they're invalid.
Signed-off-by: Silvan <silvan@auterion.com>
Mahima Yoga