This removes the param MAV_SIK_RADIO_ID and replaces it with a MAVLink
command to set the radio's net ID.
Using a command has the benefit that we get feedback whether the change
has been accepted. The code now also reads back the bytes after doing
the config in order to check for the radio's OK feedback.
Previously, the commands were just sent blindly and there is the chance
they did not actually get through.
Signed-off-by: Julian Oes <julian@oes.ch>
- precision landing works incorrectly, target position is not updated during the descent above target
- _prepareLandSetpoints needs to update _land_position continuously
Co-authored-by: kapacheuski <kapacheuski@gmail.com>
- the thermal offsets are an optional correction applied to the raw data, so when updating an existing calibration offset with new learned bias we don't want this incorporated
- EKF isTimedOut(), isRecent(), and isNewestSampleRecent() need to handle the case where the timestamp has never been set
- reset() more thoroughly reset fields (mainly impacts unit tests)
Set this flag to true if local position is valid but accuracy low, such that
the operator can be warned before system switches to position-failure failsafe.
Additionally, switch to RTL if currently in Mission or Loiter to try to reach home
or fly out of GNSS-denied area.
Set low accuracy threshold to 50m by default for FW and VTOL.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Otherwise the flight time restriction flag gets cleared too early, before
disarming (which puts the vehicle into the previous mode and it might
take off again).
Fixes the following case:
- user intention set to X
- failsafe triggers, mode = Y
- can_run for X becomes false
- user tries to switch to X
-> need to re-evaluate can_run
Previously, it was not possible to enable forwarding of messages to/from
teh USB instance because it does not have a param for it, like the
serial instances have.
With this commit, we change the default to always set forwarding on for
the USB instance as that is likely desired.
Signed-off-by: Julian Oes <julian@oes.ch>
- from the C standard, "All identifiers that begin with an underscore and either an uppercase letter or another underscore are always reserved for any use"
- from the C standard, "All identifiers that begin with an underscore and either an uppercase letter or another underscore are always reserved for any use"
The static object is destroyed on at_exit while threads might still be
inside a CS. This can lead to a hanging process.
Cleaner would be to gracefully stop the threads.
According to https://linux.die.net/man/3/pthread_cond_destroy:
Attempting to destroy a condition variable upon which other threads are
currently blocked results in undefined behavior.
