The arming button required some refactoring in order to support to
toggle arm/disarm using the vehicle_command. Otherwise manual_control
would have to subscribe to the arming topic and we would spread out the
logic again, and risk race conditions.
Instead of only looking at the diff between two RC samples to decide
whether a user wants to override, we now look at the filtered diff over
one second. This should be more robust to RC sent at various or varying
rates.
This moves the remaining handling of the manual control stuff out
of commander. All communication between manual control now goes through
vehicle commands, and the landing gear topic.
This is an intermediate solution to carry forward the initial state of
the mode slot. Basically, it allows that we start up in Stabilized but
switch to POSCTL as soon we have the required GPS.
This adds a selector class with unit tests.
The idea is to have a valid flag in manual_control_septoint and set that
according to the selection and/or timeout of manual_control_inputs.
* ekf2: make publishing of learned accel biases more robust
* ekf2: reset accel bias if calibration updated
* msg: add separate accel and gyro calibration counters
* ekf2: use separate accel and gyro calibration counters
* ekf2: rework logic to reset biases when calibration counters increment
* sensors: add saving of learned accel biases
* ekf2: generalized saving accel/gyro/mag in flight sensor calibration
* boards: holybro kakutef7 disable systemcmds/perf and systemcmds/top to save flash
Co-authored-by: Paul Riseborough <gncsolns@gmail.com>
- mavlink/mavlink is now directly included as a submodule instead of the generated mavlink/c_library_v2
- this also switches to mavlink development.xml by default
The SERIAL_CONTROL MAVLink message now contains a target_system and
target_component field that we should check.
Without this we might be answering to a command on the network that is
meant for another system.
- added ability to specify maximum acceleration constraint for height rate setpoint
- added support for locking altitude setpoint when in height rate control
mode and height rate input is zero
Signed-off-by: RomanBapst <bapstroman@gmail.com>
