* ci: lockdown gcc v9 for macos
Signed-off-by: Ramon Roche <mrpollo@gmail.com>
* pxh: do not use variable sized array on the stack
This is a compiler-specific extension
* ci: macos build on older gcc
Signed-off-by: Ramon Roche <mrpollo@gmail.com>
---------
Signed-off-by: Ramon Roche <mrpollo@gmail.com>
Co-authored-by: Beat Küng <beat-kueng@gmx.net>
* [Docs] PX4 v1.16 Add warning for RTL mode issues in return.md
Added a warning about known issues with RTL mode during fixed-wing approaches and landings.
* Apply suggestion from @hamishwillee
* Apply suggestion from @hamishwillee
* MulticopterPositionControl: Add timeout before triggering emergency setpoint on invalid TrajectorySetpoint
* Apply suggestions from code review
* Cleanup & address review comments
* Safegaurd against using old setpoint if states aren't valid anymore
---------
Co-authored-by: Jacob Dahl <37091262+dakejahl@users.noreply.github.com>
Freeing the DMA stream in the hrt callback causes other peripherals on that DMA controller to lock up (namely GPS). Moving the free back into thread context, right before allocation, solves the problem
- Adds MSPv1 rx parsing to fetch VTX config
- Allows to inspect and change VTX channel through CLI
- Forward MSP_RC for stick commands osd
- Forward MSP_STATUS for arming status for PIT and LP mode
I don't think we have a way to explicitly detect if BAT1 or BAT2
"bricks" are correct, so we have to assume they are, and rely on the
voltage/current shown.
Additionally, we can now power cycle sensor power.
It turns out that we set the ADC range incorrectly leading to the
measured current being capped at a certain level as the ADC on the
sensor saturates.
Instead, we need to set the range according to the formula given in the
interface datasheet.
* hrt: Fix PPM input on channel 2
The CCMR1_PPM define for PPM input on channel 2 was incorrectly set to 2,
which was setting bits for channel 1 instead of channel 2. This prevented
PPM input from functioning properly on channel 2.
Changed CCMR1_PPM for channel 2 from 2 to (1 << 8), which correctly
configures the CC2S bits for input capture mode on TI2.
This fixes an issue noted in the existing code comment:
"FIXME! There is an interaction in the CCMR registers that prevents
using Chan 1 as the timer and chan 2 as the PPM"
Tested on STM32H743 with PPM input on PC7 (TIM8_CH2).
* rc_input: enable sharing serial and PPM pin
By setting RC_SERIAL_PORT_SHARED_PPM_PIN_GPIO_RX it is now possible to
use the same pin on the STM32 for PPM input as well as serial input.
* boards: Add support for Holybro KakuteH7-Wing
---------
Co-authored-by: Julian Oes <julian@oes.ch>
