px4io_update: Add px4io FW on nxp_fmurt1062-v2
nxp_fmurt1062-v2:Use DMA on SPI
nxp_fmurt1062-v2:Timer configuration for 1 channel per group (timer)
nxp_fmurt1062-v2:Normalize with V5X - start PX4IO and Mavlink on TELEM2
nxp_fmurt1062-v2:Update PX4IO Firmware
nxp_fmurt1062-v2:Normalize boardconfig to upstream
nxp_fmurt1062-v2:Corect roataion of ICM20602
nxp_fmurt1062-v2 RC04 HW Changes
nxp_fmurt1062-v2:Use TJA1103 PHY
nxp_fmurt1062-v2:Update to NuttX 10.3+
nxp_fmurt1062:Use Buffer based HW flow control
nxp_fmurt1062-v2:Free Memory
nxp_fmurt1062-v2:Remove fixed wing
* Cyphal: fix comparing floating-point issue
* Cyphal: fix setpoint serialization
* Cyphal: fix bug with wrong comparasion of param name and pub/sub name: remove prefix from UavcanPublisher::updateParam and UavcanDynamicPortSubscriber::updateParam and PublicationManager::updateDynamicPublications
* Cyphal: integrate UavcanEscController with PublicationManager, remove second instance of UavcanEscController from CyphalNode
* Cyphal: publish readiness with minimal frequency because according to UDRAL The drive shall enter STANDBY state automatically if the readiness subject is not updated for CONTROL_TIMEOUT
* Cyphal: increase setpoint publish rate from ~75 to 200 by removing PX4_INFO (it really significantly react on the the output rate) and changing the mixing output rate and the shedule interval
* Cyphal: restore prefix because we need it for uorb over uavcan/cyphal and add udral prefix for non uorb pub/sub
* Cyphal: fix DynamicPortSubscriber subscription: if it has multiple subscribers, it should call subscription only after updating of all port subscribers port identifiers
* Cyphal: fix SubscriptionManager: we should take care about prefix
* Cyphal: fix readiness for test motor mode
* [Cyphal] Fix dynamicsubscription, improve printinfo, enable MR-CANHUBK3 config
---------
Co-authored-by: Peter van der Perk <peter.vanderperk@nxp.com>
- during casual testing on default configs the stack was penetration was reaching ~90% which is a bit too close for comfort
- increasing by 50% to be conservative
* Fixedwing rate control into a separate module
* Start fw_rate_control for vtol
* Move over airspeed related parameters to fw_rate_control
Co-authored-by: Silvan Fuhrer <silvan@auterion.com>
- update all msgs to be directly compatible with ROS2
- microdds_client improvements
- timesync
- reduced code size
- add to most default builds if we can afford it
- lots of other little changes
- purge fastrtps (I tried to save this multiple times, but kept hitting roadblocks)
David Sidrane