* add qmc5883p drivers
* format correction for qmc5883p
* make format
* remove extra newlines
---------
Co-authored-by: Jacob Dahl <dahl.jakejacob@gmail.com>
- timestamp was 0 if uavcan::BatteryInfo was received before uavcan::BatteryInfoAux
- scale was not set as unknown (-1) even though it is since it's never updated
- time_remaining was not initialized correctly and could sometimes be 0
unexpectedly which causes the drone to failsafe because there's reportedly no flight time left
_message.header.length - 4 is passed as unsigned to the CRC method, so if
_message.header.length < 4, the length wraps and causes invalid memory
access.
- Adds MSPv1 rx parsing to fetch VTX config
- Allows to inspect and change VTX channel through CLI
- Forward MSP_RC for stick commands osd
- Forward MSP_STATUS for arming status for PIT and LP mode
It turns out that we set the ADC range incorrectly leading to the
measured current being capped at a certain level as the ADC on the
sensor saturates.
Instead, we need to set the range according to the formula given in the
interface datasheet.
* adis16507: enhance driver to handle and recover from all failure modes
- Clean up driver
- Add optional hardware reset
- Fix scale and range for 125 deg/s variant
- Handle communication errors when read returns zeroes
- Improved perf counters
* change prints to PX4_DEBUG, define BURST_READ_CMD, do both soft and hard reset, use ScheduleNow instead of 1ms delay, change read/write stall period to SPI_STALL value
* hrt: Fix PPM input on channel 2
The CCMR1_PPM define for PPM input on channel 2 was incorrectly set to 2,
which was setting bits for channel 1 instead of channel 2. This prevented
PPM input from functioning properly on channel 2.
Changed CCMR1_PPM for channel 2 from 2 to (1 << 8), which correctly
configures the CC2S bits for input capture mode on TI2.
This fixes an issue noted in the existing code comment:
"FIXME! There is an interaction in the CCMR registers that prevents
using Chan 1 as the timer and chan 2 as the PPM"
Tested on STM32H743 with PPM input on PC7 (TIM8_CH2).
* rc_input: enable sharing serial and PPM pin
By setting RC_SERIAL_PORT_SHARED_PPM_PIN_GPIO_RX it is now possible to
use the same pin on the STM32 for PPM input as well as serial input.
* boards: Add support for Holybro KakuteH7-Wing
The older defines without the L for the APB1 Low domain errored for some
of the timers, such as 6 and 7.
I checked and it turns out the defines with and without L are identical.
We need to open the device later in the work queue and not in the
constructor during task_spawn.
There is already a lazy open in place, so just removing this fixes the
problem for me.
QiTao Weng