-constrain range to -20..35°C
-do not use temperature readings if exactly 0 (as likley not filled by driver at all in this case)
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- this fixes a minor edge case when you only have a single accelerometer and haven't made any parameter changes, the sensor sample rate (used for filtering) might not have been updated from default
If the GPS data is passed from companion computer, there may be inaccuracies
with timesync. This may cause time deltas to overflow.
Make the time delta calculation using floats directly, wich results in negative
numbers in case there are such inaccuracies.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
- no warning if accel is disabled
- threshold increased 100 -> 1000 (only warn if severe ongoing clipping)
- more generic warning message (vehicle isn't necessarily in air flying)
For the sake of efficiency (at 8 kHz) all filtering is performed on the raw data before the calibration and rotation is applied to only the final output. As a result we have to be a bit more careful when switching between sensors or in cases where the gyro scale factor changes (eg icm42688p 20 bit data rescaled to fit in int16 output).
- rotates accel & gyro FIFO data before publication both to simplify downstream usage (including log review) and fix other issues
- to best handle int16_t data rotations are now either performed with swaps if possible, otherwise promoted to float, rotated using the full rotation matrix, then rounded back to int16_t
- fix sensors/vehicle_angular_velocity filter reset both with proper rotation and new calibration uncorrect helper
- in FIFO case filtering is done before calibration is applied, but we need to handle a possible reset from a completely different sensor (vehicle body angular velocity -> sensor frame uncorrected data)
- in multi-EKF mode the EKF selector becomes repsonsible for sensor
selector rather than the sensors module
- this updates the sensors module to still make the initial primary IMU
selection on startup before the EKF selector (including if the
estimators never fully initialize)
- generate PWM_MAIN 1-14
- generate PWM_AUX 1-8
- generate PWM_EXTRA 1-8
- px4io and pwm_out directly read configuration parameters
- only available and active physical outputs are actually shown for configuration
- overall saves flash despite adding many new parameters
- parameter updates can be quite expensive because they trigger nearly all modules to reload all of their parameters immediately
- limit modules from updating faster than once per second
Daniel Agar