To separate accuracy requirements for VTOL hover and cruise.
- global_position_relaxed refers to having a valid horizontal velocity aid source
in the estimator and a set global reference position, but poses no requirements
on the accuracy of the provided position estimate.
- Auto flight modes Mission, Loiter and RTL, while in fixed-wing mode,
only require the relaxed global position going forward
- COM_POS_FS_EPH is thus no longer used on fixed-wing vehicles (resp. VTOL in FW)
- rename failsafe_flags.local_position_accuracy_low to failsafe_flags.position_accuracy_low
---------
Signed-off-by: RomanBapst <bapstroman@gmail.com>
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Co-authored-by: Silvan <silvan@auterion.com>
It currently defaults to 1g for multirotors, which works in most cases. However, during extended high-acceleration flight (e.g. in Stabilized mode), the limited dynamic model can upset the EKF, causing repeated resets due to data inconsistencies. Recovery is sometimes quick but can also be too slow to maintain position after high acceleration flight. This issue was observed on an 850mm vehicle, not a racer.
I don't think we have a way to explicitly detect if BAT1 or BAT2
"bricks" are correct, so we have to assume they are, and rely on the
voltage/current shown.
Additionally, we can now power cycle sensor power.
add RunwayControl messge to pass wheel steering controls to wheel controller
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Runway takeoff: specify that RWTO_TKOFF is directly applied during takeoff
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
msg/RateCtrlStatus: remove unused wheel_rate_integ field
The wheel rate controller is not run in the moduels that are now
running the MC/FW rate controllers, so thsi field canot be filled.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
wheel rate controller: use speed scaler quadratically on integrator
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
wheel yaw controller: use a time constant of 0.1
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
FW Attitude Controller: lock heading setpoint for wheels to initial heading
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Params that are used by FW Mode Manager
- FW NPFG: NPFG params, should be renamed to FW Lateral Control once moved to the lat/lon controller
- FW Auto Takeoff
- FW Auto Landing
Params used by Fw Lat/Long Controller:
- FW Lateral Control
- FW Longitudinal Control
Params used by both:
- FW General
Params used by Performance model:
- FW Performance (could be moerged with FW General?)
Signed-off-by: Silvan <silvan@auterion.com>
- split up old module into two, one handling setpoint generation, one control
- add lateral and longitudinal control setpoints topics that can also be
injected from companion computer
- add configuration topics that (optionally) configure the controller
with limits and momentary settings
Signed-off-by: RomanBapst <bapstroman@gmail.com>
To make sure QGC also shows a box and reads out for "low battery"
and make events and mavlink_log reports consistent.
Low - Critical
Critical - Critical
Emergency - Emergency
Niklas Hauser