actuator_motors and actuator_servos subscribers for offboard control
Being subscribers, this does not increase the computational load
over the uxrce_dds brigde
Signed-off-by: Beniamino Pozzan <beniamino.pozzan@gmail.com>
New thrust and torque control mode added which replaces the previous
actuator mode,
in this mode the rate controllers are disables, the control allocator
is enabled and the used externally provices
vehicle_thrust_setpoints and vehicle_torque_setpoints.
New direct_actuator mode
In direct_actuator mode the control allocator module does not publish
actuator_motors and actuator_servos messages which must instead be
provided extrernally by the user.
Removed old direct mode.
Signed-off-by: Beniamino Pozzan <beniamino.pozzan@gmail.com>
* Added parameter UXRCE_DDS_SYNCC to enable system clock synchronization. Refactored and cleaned up. Only set system time if it's off by more than 5 seconds (same as mavlink and gps).
Only re-evaluate if no longer in GF when flight mode is changed or
Loiter position was changed (eg through goto).
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- check if Home would breach it (we do not want to upload GF that
do not allow to return to Home)
- check if the current vehicle position isn't contained in the GF
if armed (as then it would immediately trigger)
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- do reporting of breaching in-air only in geofenceCheck
- remove geofence_violation_reason_t
- replace geofence_breached field in GeofenceResult.msg with 3 fields
(one for each GF type: max dist, max alt, custom geofence)
- the warning message after breaching a GF is only done by Commander,
and it's specific to the GF type failure
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Use flow rates instead of integrals in backend. This allows us to delay
the data to the mitpoint integration time and simplifies the code in
general.
Gyro compensation can still be done in EKF2 if needed, but the
flow module normally already appends the correct gyro data to the flow
message.
* created a Performance Model for fixed wing vehicle
- added compensation for maximum climbrate, minimum sinkrate, minimum airspeed and trim airspeed based on weight ratio and air density
- added atmosphere lib to standard atmosphere calculations
---------
Signed-off-by: RomanBapst <bapstroman@gmail.com>
Co-authored-by: Thomas Stastny <thomas.stastny@auterion.com>
- in theory these are helpful to ensure EKF2_HGT_MODE configuration is
consistent with the relevant aid source (GPS, baro, etc), but it can
be a little awkward with users having to fight manual parameter
changes in the right order
Konrad