On boot, if board_hardfault_init finds a hardfault stored in BBSRAM, it
checks if there is any data available on stdin to see if there is
somebody there to respond to a prompt. But on boards such as cubeorange
where there is not a serial console by default, the ioctl fails and
bytesWaiting is uninitialized. So it will non-deterministally hang the
boot process with no outside feedback if that value is not zero.
Signed-off-by: Alex Mikhalev <alexmikhalevalex@gmail.com>
Sometimes, the mission_result timestamp is the same as the
internal_state timestamp which would meant that we would not switch to
LOITER even though the takeoff is clearly done at that point.
I observed stack overflows when executing `uavcan params list`, so the
stack size probably needs to be increased.
Signed-off-by: Alex Mikhalev <alexmikhalevalex@gmail.com>
- auto disarm when locked down was added in #14766 to prevent user confusion in regular usage, but also breaks HITL where lockdown is enabled for safety
- fixes#15686
It loads the battery parameters but then overwrites them
with hardcoded values and it breaks the ModuleParams
parent/child hierarchy. Both is undesired.
* X7Pro adds CAN driver
* UAVCAN timer selection moved to default.cmake
* Modify some details about @CUAVcaijie UAVCAN timer selection moved to default.cmake
* Put some timer parameters to micro_hal.h from board_config.h. Fix all h7 boards
Co-authored-by: honglang <honglang@cuav.net>
- perform reset as per the datasheet (disable I2C immediately, set power mode, wait for appropriate time, etc)
- remove interrupt perf counter and instead only count misses
- minor style changes to stay in sync with the other Invensense drivers
- perform reset as per the datasheet (disable I2C immediately, set power mode, wait for appropriate time, etc)
- only track consecutive errors (not total) to trigger full reset if necessary
- remove interrupt perf counter and instead only count misses
- minor style changes to stay in sync with the other Invensense drivers
- perform reset as per the datasheet (disable I2C immediately, set power mode, wait for appropriate time, etc)
- only track consecutive errors (not total) to trigger full reset if necessary
- remove interrupt perf counter and instead only count misses
- minor style changes to stay in sync with the other Invensense drivers
- perform reset as per the datasheet (wakeup accel/gyro and wait before proceeding)
- add register bank selection (not yet used)
- track consecutive errors to trigger full reset if necessary
- remove interrupt perf counter and instead only count misses
- minor style changes to stay in sync with the other Invensense drivers
