- As it is always only used for the vehicle command ack message
- It was a duplicate, hence making it error prone for maintainment
- The uORB message comments were updated to make the relationship with
the MAVLink message / enum definitions clear
- all sources of optical flow publish sensor_optical_flow
- sensor_optical_flow is aggregated by the sensors module, aligned with integrated gyro, and published as vehicle_optical_flow
Co-authored-by: alexklimaj <alex@arkelectron.com>
internal PX4IO safety_off state is removed and replaced with a normal safety button event. From this 'commit' commander is taking care of the PX4IO safety.
H7 Only supports 2 not 3 CAN interfaces.
CanInitHelper passes in in the run time configuration of
the number of interfaces. The code was ignoring these!
internal PX4IO safety_off state is removed and replaced with a normal safety button event. From this 'commit' commander is taking care of the PX4IO safety.
- fixes the deadlock in px4io ioctl mixer reset
- px4io Run() locks (CDev semaphore)
- mixer load goes through px4io ioctl MIXERIOCRESET which calls MixingOutput::resetMixerThreadSafe()
- MixingOutput::resetMixerThreadSafe() stores a Command::Type::resetMixer command in an atomic variable, schedules a work queue cycle, then sleep spins until the command is cleared
- the execution of the cycle eventually calls back into PX4IO::updateOutputs(), which tries to lock (and waits forever)
- sensor_baro.msg use SI (pressure in Pascals)
- update all barometer drivers to publish directly and remove PX4Barometer helper
- introduce baro cal (offset) mainly as a mechanism to adjust
relative priority
- commander: add simple baro cal that sets baro offsets to align with
GPS altitude (if available)
- create new sensors_status.msg to generalize sensor reporting
and remove the possibility to set min > max to reverse.
Initially the idea was to add the checkbox on the UI side, to avoid adding
another param, but I don't think I'll go through the extra effort on the
QGC side.
- uavcan firmware server no longer shuts down when arming (nodes might restart in flight)
- always handle UAVCAN parameters with or without the FW server active
- remove legacy ESC enumeration in FW server
The current practice of adding topics to the default set isn't scalable,
as it affects all setups.
By making sure topics are advertised on init, logger can just discard
topics that don't exist. This does not work for all topics, so topics are
specifically marked as optional. It can be extended to more topics later
on though.
This reduces the list of topics by ~35 on a pixracer configured as quad,
and reduces RAM usage by ~1KB.
Hamish Willee