- Also use the delayed current data instead of newest that might not be
available (gps buffer is sometimes empty if the dt between samples is
larger than the delayed horizon).
- Separate "baro fault" from "baro intermittent": intermittent is a
temporary failure and should prevent from switching to baro right now,
but "fault" means that it should never be used anymore
- In case of height timeout, check for metrics but not for consistency
as the filter is likely to have diverged already.
Once we have valid input we should use that and not overwrite our
update_result with the result from other inputs, otherwise the
automatic selection does not actually work.
This behavior means that only the first update will be used if there are
several sources updating in the same cycle.
Weak authority on a axis is currently defined as: none of the actuators have an
effectivness on this particular axis larger than 0.05.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
* Navigator: enable DO_CHANGE_SPEED for outside of mission
- update _mission_cruising_speed_mc/_fw also if DO_CHANGE_SPEED command
is received outside of mission (e.g. while Loitering doing an Orbit)
- if vehicle is in AUTO_LOITER when receiving the change speed, then immediately
apply it by doing a reposition without updating any other field than cruising_speed
and cruising_throttle
-when RTL is activated reset the cruising speed and throttle
* Navigator: reset cruise speed and throttle to default when VTOL-transitioning
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
-pass flag EffectivenessUpdateReason into effectiveness, indicating if there was an external
update or not. Reasons for external updates are:
-config changes (parameter)
-motor failure detected or certain redundant motors are switched off to save energy
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
This fixes the issue when changing the altitude during a goto for
example, where the vehicle was going backwards and upwards to reach the
closest point to the line. Now the vehicle simply goes towards the
target waypoint.
This is the case for boards with digital readout, like v5x, but still
enable the battery_status module for external analog driver options.
An alternative would be to not run battery_status depending on config.
This is a bigger refactor of vmount to clean it up and plug some holes
in functionality.
The changes include:
- Fixing/simplifying the test command.
- Changing the dependencies of the input and output classes to just the
parameter list.
- Adding a separate topic to publish gimbal v1 commands to avoid
polluting the vehicle_command topic.
- Removing outdated comments and author lists.
- Extracting the gimbal v2 "in control" notion outside into control_data
rather than only the v2 input.