Use reporting from the motor mixer to only restrict integrator growth when it will result in increased saturation of the control axis concerned.
Enable absolute integrator limits to be set by parameter
According to https://github.com/mavlink/mavlink/pull/629 the mavlink
command DO_SET_MODE should only determine the mode but not the
armed/disarmed state, so the MAV_MODE_FLAG_SAFETY_ARMED bit should be
ignored.
Instead the mavlink command COMPONENT_ARM_DISARM should be used instead.
Therefore, the commander now ignores the arm/disarm bit.
clamp mixer output offset to [-.2,.2] ([-2000, 2000] in mixer file)
add 8 main PWM trim parameters
add long desc to parameters and bump minor parameter version
This fixes the following corner case:
1. Upload a mission.
2. Set mission mode.
3. Set loiter mode.
4. Arm.
At this point it will shoot up and go to the takeoff waypoint even
though we're not in mission but in loiter mode.
The fix makes sure that the triplet is reset to invalid (and idle) in
loiter mode if we're landed and disarmed.
It will lead to the vehcle sit in idle on the ground until you issue a
start mission (or takeoff) command.
- fix a bug where the wrong rotation order was used to compute the attitude
setpoint when using the pusher assist feature
Signed-off-by: Roman <bapstroman@gmail.com>
- fixed a bug where tilt compensation was done also when the horizontal
velocity was controlled. This is not needed because in this case
the controller outputs a 3D thrust vector.
Signed-off-by: Roman <bapstroman@gmail.com>
(leads to double publishing on the console when a new link is established, but this is the best compromise between fixing and completely restructuring)
This resolves a bug where a takeoff would go sideways instead of
straight up. What happened was that the position setpoint got shifted
around even though there was actually no real setpoint set but only a
setpoint of type IDLE. This then lead to a position setpoint far away
from the takeoff point and therefore scary takeoffs.
This fix prevents the part of the position controller which
moves/integrates the position setpoint from running in the case of an
idle setpoint.
This bug could be reproduced by switching the vehicle to mission mode
without a valid mission, then switch to hold mode, and then send the arm
and takeoff command.
Paul Riseborough