I could not extract the open_drone_id helpers to a separate lib because
it would require the mavlink headers while the mavlink library would
also depend on it, so it ended up being a circular dependency.
Instead, I'm now just using the headers from within the mavlink module
as well as from the uavcan driver.
This will send the System message if it is already being sent by a ground
station. Otherwise, it will assemble the message itself using the
takeoff/home location.
This extracts the function mapping from MAV_TYPE to MAV_ODID_UA_TYPE to
the library, so that it can be re-used later by the remote ID
implementation over DroneCAN.
Signed-off-by: Julian Oes <julian@oes.ch>
* Remove euler angles from attitude setpoint message
* Remove usage of euler angles in attitude setpoint messages
This commit removes the usage of euler angles in the vehicle_attitude_setpoint messages
* Fix standard vtol
This adds explicit handling for the few things we want to allow through a MAVLink instance dedicated to a gimbal/(camera) payload as per the MAVLink gimbal mode configuration.
Without this flag the command silently succeeds even though the logs contains
an error. It's much more developer friendly to fail early in case of an error.
The log path is then also shown in the console output.
The case where the airframe maintainer wants to enforce a reset to airframe is
not covered anymore with the `param set-default` mechanism. For products based
on PX4 this is still required to ensure proper functionality after a major update.
* usb: Added parameter to enable always starting mavlink on USB.
Refactored cdcacm_init into a module and added a paramter to allow always starting mavlink on
USB, also added a paramter to choose the mode. The current default behavior is to wait and listen
for data on USB and auto-detect the protocol (mavlink, nsh, ublox). This results in the mavlink
stream not starting until something else on the mavlink network sends a packet first. The new
default behavior is to always start mavlink.
Added parameters
MAV_USB_ENABLE -- default 1 (always start mavlink on USB)
MAV_USE_MODE -- default 3 (onboard)
* added 3 retries for opening serial port in mavlink, removed sleep before sercon
* added DRIVERS_CDCACM_AUTOSTART to ark-v6x default.px4board
* added CONFIG_DRIVERS_CDCACM_AUTOSTART=y to default.px4board for boards with CONFIG_CDCACM in their nsh/defconfig
* format
* remove PGA460 from COMMON_DISTANCE_SENSOR to save flash
* remove LIS2MDL from COMMON_MAGNETOMETER to save flash
* disable CONFIG_DRIVERS_CDCACM_AUTOSTART for fmu-v5 protected.px4board
* moved and renamed parameters, removed mode logic in mavlink
* changed parameter names, added mode none
* remove parameters from mavlink
Regression from https://github.com/PX4/PX4-Autopilot/pull/23043
Also avoids a race condition by making sure the command ack is handled
before sending out the mavlink message (in case an external component
reacts immediately to the mavlink message).
Matthias Grob