The UARTs themselves were already present, just not configured under any
alias.
Follow [ArduPilot UART naming for this
board](https://ardupilot.org/plane/docs/common-pixracer-pro.html#default-uart-order),
out of necessity: it's the only combination that makes sense and is
understood by QGroundControl.
(For example, I've attempted configuring the additional UARTs as `_EXT1`
and `_EXT2`, but only `_EXT2` was understood by QGC.)
Trying to actually use the FrSky telemetry port for anything without
configuring FrSky telemetry on a different port may be impossible without
modifying the board's `init/rc.board_extras`.
(Should that script be modified to check if the port is used for
anything else?)
Skip naming the RC input port.
Fixes#21455.
Increases signal ampltiude on a 1Hz sin input until a target rate (R/P/Y = 0.8/0.5/0.5 rad/s) is reached. Identification signal is then scaled with this ampltitude instead of the user-defined parameter.
- removed the bug where some overflow would occur on the PWM signal when
changing the duty cycle of the signal after power up. (PWM_MAIN_DIS,
PWM_MAIN_MIN or PWM_MAIN_MAX)
removed commented code
cleanup of previous cherry-pick
Co-authored-by: henrykotze <henry@autonosky.com>
* ekf2: range height skip "unhealthy" samples, but respect timeout
- we should never directly use an "unhealthy" range finder sample for
state corrections or resets, but we also shouldn't immediately abort
active rng_hgt until the timeout has passed
* check starting_conditions_passing once
* ekf2: conditional range aid change height ref
---------
Co-authored-by: Daniel Agar <daniel@agar.ca>
- if bad vertical acceleration is detected there's an emergency case
where rejected range finder observations are allowed to be used, but
this still can't happen if the sample itself is known to be bag
* ekf2: range height skip "unhealthy" samples, but respect timeout
- we should never directly use an "unhealthy" range finder sample for
state corrections or resets, but we also shouldn't immediately abort
active rng_hgt until the timeout has passed
* check starting_conditions_passing once
---------
Co-authored-by: Jacob Dahl <dahl.jakejacob@gmail.com>
Changed ASCII command from ASCII #127 to ASCII #8
Good: Changed ASCII command from ASCII #127 to ASCII #8
Reported-by: jsm09a <https://github.com/jsm09a>
Signed-off-by: Siri <sriramj2@hotmail.com>
