* Make board_id compatible with ardupilot
* Initialize outputs for CAM1/CAM2 and Vsw pad
* Correct board type 1013 in bootloader to match AP
* Change usb vendor string to "Matek"
* Change cdcacm pid to 1013
* Comment out FLASH_BASED_PARAMS because of #15331
SD is on SPI3 - correct pin mapping
Fix DMA Mapping for all SPI and RX DMA on U[S]ART RX
Fix Memory MAP SRAM size
Removed unused GPIO
Used proper I2C definitions
Ensure Watchdog is configured for debugging
Fixed FLASH param definitions
Removed unedded SPI init
matek_gnss-m9n-f4:Correct Board ID and Size
Build order SJF
Added Support for F40x
The stackcheck build flash space overflows after adding hygrometers.
Also follow the naming convention of other similar config flags, and rename the
config.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
This goes the other way around; arch_io_pins is using the pin
definitions from drivers_board, so the drivers_board needs to be linked
into arch_io_pins
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
known issues:
- flash-based params does not work on H7 (due to ECC), so params are on
SD card. The last flash sector is still reserved however.
- output channel 6 does not support DShot (the implementation does not
handle channel gaps)
- flashing of the 2. flash bank is much slower (around 3x), than the 1.
bank for some unknown reason.
- after the BL jumps to the app, there's several seconds passing until
stm32_boardinitialize() is called.
The boot order is now:
1. The PX4 bootloader boots, and starts the camera.
2. The camera starts and sends the boot command to the PX4 bootloader.
3. PX4 starts.
This changes the way RC is handled for the Mantis:
- The RC values are re-written when arriving over MAVLink. They are
rescaled from 0..4095 to 1000..2000 and the channel bits added to
separate channels. This makes the downstream handling easier.
- Gimbal pitch is moved from Aux1 to Aux2 as that should be the default.
- Aux3 and Aux4 are used for the photo and video trigger.
- The speed button is used as the FLTMODE channel and set to switch
between POSCTL and ALTCTL.
This adds a check for the previous SYS_AUTOSTART id. If it is still the
old/previous SYS_AUTOSTART id, it will flash the new bootloader as well
as set the proper SYS_AUTOSTART id.
To play a power off tune, I needed to convert the file to C++, so that I
could use the uORB::Publication.
The current implementation starts playing the power off sound but then
stops it as soon as the button is released.
The problem is mostly that we only get an interrupt when the button is
pressed or released but we don't seem to be able to poll it, at least
not in the current state.
This adds the env option PX4_FUZZ which runs the LLVM libFuzzer which
throws random bytes at mavlink_receiver using MAVLink messages over UDP.
The MAVLink messages that are being sent are valid, so the CRC is
calculated but the payload and msgid, etc. are generally garbage, unless
the fuzzing gets a msgid right by chance.
As I understand it, libFuzzer watches the test coverage and will try to
execute as much of the code as possible.
