* heater: add multi-instance support, refactor parameter handling, remove legacy params file
This change introduces multi-instance heater support to allow independent temperature control for multiple IMUs.
Main changes:
- Add support for multiple heater instances
- Refactor parameter handling to use per-instance parameters
- Remove the legacy parameter file and migrate to the updated parameter structure
This improves scalability and makes heater configuration consistent across setups with multiple sensors.
* Refactor heater configuration across multiple boards
- Updated heater GPIO definitions to introduce a new naming convention for better clarity and consistency.
- Replaced `GPIO_HEATER_OUTPUT` with `GPIO_HEATER1_OUTPUT` and adjusted the corresponding output enable macros.
- Changed parameter names from `SENS_TEMP_ID` to `HEATER1_IMU_ID` in various board default configurations to reflect the new heater setup.
- Ensured all affected board configurations are updated to maintain functionality with the new heater definitions.
* heater: fix missing HEATER1_OUTPUT_EN control
* heater: fix more missing HEATER1_OUTPUT_EN control
* heater: tidy config, docs, and instance handling
- Remove unused controller period member and use CONTROLLER_PERIOD_DEFAULT
- Improve HEATER${i}_IMU_ID description and instance-related logging/behavior
- Add a guard when HEATER_NUM exceeds HEATER_MAX_INSTANCES
Note: drop intermediate/reverted change around the 'celsius' spelling.
* heater: refactor constructor to remove unused parameter and add instance name function
- Remove unused ModuleParams argument from Heater constructor
- Add heater_instance_name() helper to provide per-instance work queue task names
- Use instance-specific parameter lookup (HEATER{n}_*) during initialization
Use heater_instance_name() to label each instance (heater_1/2/3) in work queue.
Also drop unused ModuleParams argument from constructor and keep per-instance
parameter handle lookup in initialization.
* format
* board: update GPIO configuration for multiple heater instances, add HEATER_NUM for boards using PX4IO
* heater: update heater control to use HEATER1_OUTPUT_EN when using PX4IO for consistency
* heater: add a TODO for px4io multi-instance
* heater: update missing GPIO_HEATER1_OUTPUT in sky-drones
* heater: fix multiple newlines at EOF (resolve CI check failure)
* heater: switch to PublicationMulti for heater_status and log multi-instance
- Changed _heater_status_pub from Publication to PublicationMulti to support independent per-instance publications without overwriting.
- Updated logged_topics.cpp to use add_optional_topic_multi("heater_status")
This fixes the issue where multiple heater instances were writing to the same heater_status topic, causing data overwriting and incorrect update rates in logs.
---------
Co-authored-by: Jacob Dahl <dahl.jakejacob@gmail.com>
Co-authored-by: Jacob Dahl <37091262+dakejahl@users.noreply.github.com>
- no longer start sercon or mavlink usb by default
- on USB connection (VBUS) monitor serial USB at low rate and start Mavlink if there's a HEARTBEAT or nshterm on 3 consecutive carriage returns
- the mavlink USB instance is automatically stopped and serdis executed if USB is disconnected
- skipping Mavlink USB (and sercon) saves a considerable amount of memory on older boards
- generate PWM_MAIN 1-14
- generate PWM_AUX 1-8
- generate PWM_EXTRA 1-8
- px4io and pwm_out directly read configuration parameters
- only available and active physical outputs are actually shown for configuration
- overall saves flash despite adding many new parameters
- simple state machine to reset, configure, etc
- checked register mechanism (sensor will reset itself on configuration error)
- configured in 16 bit mode (1320 LSB/Gauss instead of 330 LSB/Gauss)
- adjusted orientation handling in driver to match datasheet as closely as possible
- in many external compass units the rotation was wrong and very difficult to actual determine how to set correctly
