chfriedrich98
5c64a3ed93
Rover Ackermann module ( #23024 )
...
New module handling Ackermann rover guidance and control.
Only enabled in SITL and in the rover builds for now.
2024-06-07 17:15:12 +02:00
Silvan Fuhrer
831160389e
VTOL Tailsitter: remove throttle spike also for quad-chute
...
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-06-07 16:11:59 +02:00
Silvan Fuhrer
199a2f43be
VTOL Tailsitter: treat back transition abort like a front transition
...
for throttle blending.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-06-07 16:11:59 +02:00
Silvan Fuhrer
b5988ed38f
VTOL Tailsitter: add back transition throttle blending
...
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-06-07 16:11:59 +02:00
Silvan Fuhrer
f119b15ff1
VTOL Tailsitter: set differential thrust to 0 in first 50ms of front transition
...
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-06-07 16:11:59 +02:00
Silvan Fuhrer
77a3099154
VTOL Tailsitter: fix motor spikes to 0 when starting back transition
...
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-06-07 16:11:59 +02:00
Silvan Fuhrer
3a2b973aba
VTOL Tailsitter: add front transition throttle blending
...
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-06-07 16:11:59 +02:00
Silvan Fuhrer
a081354933
VTOL tailsitter: fix motor spike to 0 when finishing front transition
...
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-06-07 16:11:59 +02:00
Silvan Fuhrer
1f7b4843dd
FW position control: specify modes where FW_PN_R_SLEW_MAX applies
...
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-06-07 09:32:23 +02:00
Silvan Fuhrer
b53d2cdf39
battery: reset current filter when transitioning to FW ( #22256 )
...
VTOLs consume a lot more power in hover copared to fixed-wing fligt.
The remaining flight time thus should reset if one switches from MC to FW,
as otherwise it takes several minutes until the estimate goes down.
2024-06-07 09:28:37 +02:00
Daniel Agar
fb659ae200
ekf2: stopMagFusion() reset yaw_align if mag heading was active
...
- we also need to clear mag_aligned_in_flight
2024-06-06 10:08:20 -04:00
Daniel Agar
bfe3c86aeb
ekf2: merge mag yaw angle observability into heading consistency
...
- the additional hyteresis logic for "yaw angle observable" was
needed when it controlled time dependent mag_3d
2024-06-06 10:07:31 -04:00
Matthias Grob
68769ea0ec
mavlink: use reference instead of pointer to access the MAVLink instance from protocol classes
2024-06-05 16:13:52 +02:00
Matthias Grob
9a7a977625
mavlink_receiver: put all message handling in the same function
2024-06-05 16:13:52 +02:00
Daniel Agar
157f7cf40b
simplify world_magnetic_model interface (degrees in, degrees out)
...
- this hopefully helps avoid accidental mis-use
- try to clarify units everywhere
2024-06-04 09:14:36 -04:00
Daniel Agar
5fa3b9d86a
lib/world_magnetic_model: fetch_noaa_table.py refactor and scaling improvements
...
- upate to NOAA grid API to build WMM table in one pass
- refactor declination/inclination/totalintensity table printing to
shared method
- compute scaling factor to maximize resolution
2024-06-04 09:14:36 -04:00
Jacob Dahl
22a38c0c6d
drivers/imu: sch16t improvements ( #23221 )
...
* individual perf counters for frame errors
* don't treat saturation as an error
* added parameters for gyro/accel LPF and decimation ratio
2024-06-03 22:15:00 -04:00
Matteo Del Seppia
a8617cf681
Fix float and uint64_t comparison ( #23199 )
...
fix: ControlAllocator float and int comparison bug
There was an incorrect comparison between a float variable `dt` and a `uint64_t` value representing 5 milliseconds (`5_ms`). As a result, `do_update` could never become true even if the last torque setpoint was received more than 5 milliseconds before.
To solve this, the `5_ms` value has been converted to seconds (0.005f) for the comparison with `dt`.
2024-06-03 17:48:38 -08:00
Matteo Del Seppia
de5087ae3e
Patch for issue #22818 ( #23170 )
...
When calling "differential_drive stop" a missing return statement was causing a segmentation fault due to access to already freed memory.
2024-06-03 21:10:28 +02:00
bresch
0a665a526c
ekf2: add mag type init
...
In this mode, the mag is used to inilialize the heading.
During flight, the heading is predicted using gyros and corrected
by GNSS measurements if available.
2024-06-03 13:28:12 +02:00
Beat Küng
ca112fea8a
fix commander: make sure to count all valid mags in preflight check
...
Previously, if a mag was not required (not index 0 and not used by ekf),
it was not counted in num_enabled_and_valid_calibration.
If a user set SYS_HAS_MAG to e.g. 3, it would then trigger a preflight
failure, even if there were 3 calibrated and enabled mags.
2024-05-31 12:30:34 -04:00
bresch
53210dd8f3
ekf2-mag: with NE aiding, constrain heading drift only before takeoff
...
After takeoff, the heading is easily observable
2024-05-31 10:38:17 -04:00
bresch
3dac9af09e
ekf2-mag: do not reset on WMM change when NE aiding is active
...
The mag field states are observed. No need to reset them.
2024-05-31 10:38:17 -04:00
bresch
ee765e7859
ekf2-mag: do not reset when NE aiding is active
2024-05-31 10:38:17 -04:00
bresch
6515935b52
ekf2-mag: do not limit the earth mag field estimate
...
The EKF can recover from an initial bad earth mag field estimate.
Constraining the field is not necessary and can lead to an unpredicted
behavior of the filter.
Declination fusion is safe to run even when the horizontal field is 0
2024-05-31 10:38:17 -04:00
bresch
774b6ed3b8
ekf2-mag: do not use yaw emergency estimator to reset mag states
...
On slowly moving vehicles (e.g.: boats, rovers), the yaw estimator has
worse convergence than the main EKF. Resetting the mag states using the
yaw estimator as reference can lead to poor heading. Also, the EKF can
recover really well from initially incorrect mag states.
2024-05-31 10:38:17 -04:00
bresch
c3d984703c
ekf2-mag: remove immediate declination fusion after reset
2024-05-31 10:38:17 -04:00
bresch
a6007e4b93
ekf2-mag: turn around update_all_states condition
...
Non-functional
2024-05-31 10:38:17 -04:00
bresch
c11c75d32e
ekf2-mag: always add process noise until initial value
2024-05-31 10:38:17 -04:00
asimopunov
42f4e02d7e
bsondump: add check if bson document size is set to zero and set to decoded size ( #23088 )
2024-05-30 14:52:19 +02:00
Peter van der Perk
cd93e2982c
dshot: telemetry esc_status use sequential numbering for each motor
...
channel != telemetry_index, we've to count from 0 and increment for each enabled ESC
2024-05-30 04:56:42 -04:00
Peter van der Perk
7982f54a6a
dshot: refactoring
2024-05-30 04:56:42 -04:00
Peter van der Perk
ff6966da57
imxrt: dshot fix erpm calculation by implementing 3-bit exponent and 9-bit period
2024-05-30 04:56:42 -04:00
Peter van der Perk
5d2fda6172
dshot: bdshot fix esc offline/online checks
2024-05-30 04:56:42 -04:00
Peter van der Perk
f3ef0d6610
dshot: fix clearing out esc status
2024-05-30 04:56:42 -04:00
Peter van der Perk
e2969952d3
drivers: dshot: prepare to extend for bidrectional dshot
2024-05-30 04:56:42 -04:00
Silvan Fuhrer
752051470f
Navigator: increase default of MIS_DIST_1WP to 10km
...
The previous default of 900m leads to many warnings if left
unchanged, especially if the vehicle is already in-air when
the Mission is started.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-05-29 21:00:35 -04:00
bresch
993782cffa
ekf2: only trigger position timeout reset when hpos fusion is active
2024-05-29 20:49:14 -04:00
Jacob Dahl
a4650fd70d
HealthCheck: added health check for logger to report if it's running ( #22781 )
2024-05-29 11:56:50 +02:00
Hamish Willee
b5627f487f
camera_trigger: module docs for camera trigger driver ( #23104 )
2024-05-29 11:37:27 +02:00
Matthias Grob
d1db0addf9
CameraFeedback: shorten line length such that documentation parser works
...
This broke in 4f64acb352 and was also flagged by CI in the pr and since then.
2024-05-29 11:24:53 +02:00
Silvan Fuhrer
032ae69eee
VTOL: remove _dt passing as it's no longer used (and was wrong)
...
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-05-28 14:54:33 +02:00
Silvan Fuhrer
f8fe7c7aa3
VTOL Standard: fix transition pusher motor slew rate
...
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-05-28 14:54:33 +02:00
Matthias Grob
dfee9ca4c6
MAVLink: remove never used _mavlink_link_termination_allowed
2024-05-28 10:41:00 +02:00
Silvan Fuhrer
42bca65cbf
RTL_mission_reverse: start from previous WP if RTL is triggered while in Mission
...
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-05-27 12:03:16 +02:00
Silvan Fuhrer
b9d3b9f211
RTL_mission_fast: continue mission if RTL is triggered while in Mission
...
Signed-off-by: Silvan Fuhrer <silvan@auterion.com >
2024-05-27 12:03:16 +02:00
Jacob Dahl
da35c4adce
cdcacm_autostart: handle USB power only ( #23183 )
2024-05-25 17:16:34 -06:00
bresch
ccbcbbe268
wind_est_replay: report scale instead of inverse_scale
...
The estimator internally estimates the scale inverse, but the interface
should be the scale as "airspeed_corrected = scale * airspeed"
2024-05-24 17:25:39 +02:00
Hamish Willee
4f64acb352
Docs for camera_feedback module ( #23103 )
...
* Docs for camera_feedback module
* Update src/modules/camera_feedback/CameraFeedback.cpp
* Update src/modules/camera_feedback/CameraFeedback.cpp
2024-05-23 08:44:34 +10:00
Beat Küng
e1ffc2cdaa
commander: add check for 5V overcurrent
2024-05-22 09:34:04 +02:00