To pass from invalid to valid:
- time hysteresis
- some vertical velocity
- test ratio < 1
- low-passed signed test ratio < 1
To pass from valid to invalid:
- low-passed signed test ratio >= 1
At each new valid range measurement, the time derivative of the distance
to the ground is computed and compared with the estimated velocity.
The average of a normalized innovation squared statistic check is used
to detect a bias in the derivative of distance measurement,
indicating that the distance measurements are kinematically inconsistent
with the filter.
- sensor_baro.msg use SI (pressure in Pascals)
- update all barometer drivers to publish directly and remove PX4Barometer helper
- introduce baro cal (offset) mainly as a mechanism to adjust
relative priority
- commander: add simple baro cal that sets baro offsets to align with
GPS altitude (if available)
- create new sensors_status.msg to generalize sensor reporting
- the estimated mag bias was requiring > 30 seconds of continuous 3d
mag fusion to be reported stable (and saved back to mag cal), this
restores the original intent requiring 30 seconds of accumulated valid
3d mag fusion
- this is a more conservative default if a vehicle isn't set (no land detector running)
- handled horizontal preflight failures in commander when disarmed
rather than overloading xy_valid and v_xy_valid flags
- ekf2 no longer depend on arming or standby status
- ekf2: expose dead reckoning as control status flags
- commander:
- add GPS validity check
- in AUTO MISSION if dependent on GPS then a loss of GPS will
- Also use the delayed current data instead of newest that might not be
available (gps buffer is sometimes empty if the dt between samples is
larger than the delayed horizon).
- Separate "baro fault" from "baro intermittent": intermittent is a
temporary failure and should prevent from switching to baro right now,
but "fault" means that it should never be used anymore
- In case of height timeout, check for metrics but not for consistency
as the filter is likely to have diverged already.
- move vehicle at reset detection ekf2 -> land_detector
- ekf_unit: reduce init period
- Fake fusion is when at rest is quite strong and makes the variance reduce rapidly. Reduce the amount of time we wait before checking if the variances are still large enough.
- ekf_unit: reduce minimum vel/pos variance required after init
- Fake pos fusion has a low observation noise, making the vel/pos variances reduce quickly.
Co-authored-by:: bresch <brescianimathieu@gmail.com>
- remove class _mag_sample_delayed
- update mag fusion call graph to use mag sample delayed functionally
- Ekf::resetMagHeading()
- use low pass mag directly, but check if valid (magnitude)
- MAG_FUSE_TYPE_INDOOR treat like auto if heading required
bresch