- store parameter type and if volatile separately (saves kilobytes of flash)
- use Bitset for tracking active and changed parameters
- use atomic for autosave_enabled flag
- compile at ${MAX_CUSTOM_OPT_LEVEL} (-O2 on non flash constrained boards)
Improves compression, e.g. current params file: 62KB to 51KB
There's also a PRESET_EXTREME option, which reduces by another 2KB.
We can revisit that once needed, as it increases mem usage as well.
- implement COMP_METADATA_TYPE_VERSION & add component_version.json.gz to
ROMFS for all targets.
- implement COMP_METADATA_TYPE_PARAMETER (only enabled for SITL currently)
Behavior of the 'param import' command:
- if no file provided, parameters are marked as saved (differs from before)
- if a file is provided: parameters are not marked as saved
- new sensors work item that subscribes to N x sensor_gps and publishes vehicle_gps_position
- blending is now configurable with SENS_GPS_MASK and SENS_GPS_TAU
Co-authored-by: Jacob Crabill <jacob@volans-i.com>
Co-authored-by: Jacob Dahl <dahl.jakejacob@gmail.com>
Before #14212 the velocity control gains used in the multicopter
position controller were defined as a scale between velocity error in
one axis (or it's integral and derivative respectively) and the unit
thrust vector. The problem with this is that the normalization of the
unit thrust vector changes per vehicle or even vehicle configuration
as 0 and 100% thrust get a different physical response. That's why
the gains are now defined as scale between velocity error
(integral/derivative) and the output acceleration in m/s².
* fix param import transition for MC_DTERM_CUTOFF
The previous implementation did not work, as there was a check for
param_find_no_notification() returning PARAM_INVALID for IMU_DGYRO_CUTOFF,
and therefore would not call param_modify_on_import().
This moves param_modify_on_import() before the check and makes it modify
the bson node directly.
* parameters: fix param import transition when testing is enabled
BUILD_TESTING is used for unit test builds, PX4_TESTING is used to enable additional test material within PX4
Co-authored-by: Daniel Agar <daniel@agar.ca>
- interupt pin set active low and latch
- relax retry timeout if configure failed
- improve configured empty rate (sample rate) rounding
- fix RegisterCheck
- check FIFO count as part of full transfer and reset or adjust timing if necessary
- rename DRV_IMU_DEVTYPE_ICM20608 -> DRV_IMU_DEVTYPE_ICM20608G
Daniel Agar