During a round corner the L1 distance calculation
was only done in 2D and the z-axis coordinate
was directly coming from the next waypoint.
This lead to an unpredictable altitude profile
between two waypoints. Sometimes almost all
altitude difference was already covered during
the turn instead of going diagonally.
The param is not really required anymore with the actuator
configuration. Also, when it is set to 0, RC doesn't work for some
boards which would be nice to avoid.
Signed-off-by: Julian Oes <julian@oes.ch>
- add functionality to specify world name for simulation in case name
- add test for triggering an airspeed invalidation in case of pitot blockage
- add test for high wind (ramped up wind over short period) to NOT invalidate airspeed in this case
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Increase wind process noise default (ASPD_WIND_NSD) and gate
(ASPD_TAS_GATE) to be able to catch rapid wind increases with
the internal wind estimator of the airspeed validator.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Trust the beta innovations more compated to the TAS innovations.
That should help with detecting real airspeed failures even with
a dynamic wind estimate (as long as vehicle doesn't fly straight)
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Increasing the wind process noise results in a more dynamic
wind estimation, which is capable of catching fast-varying
winds. As wind is used in the lateral guidance it's important
that we don't filter it too much.
Furher the gate of the airspeed fusion is increased, to
reduce the likelihood of airspeed fusion stopping due to
dynamic wind conditions. The airspeed is validated in
the airspeed validator (EKF consumes the validated one).
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Reduces flash usage by ~16KB.
- compress formats at build-time into a single string with all formats
- then at runtime iteratively decompress using
https://github.com/atomicobject/heatshrink
- if not in air the accel noise is doubled
- if landed don't init unless GPS velocity is non-negligible
- when inactive continue seeding with EKF gyro bias
- reset yaw estimator if GPS fusion is stopped
Has options *None where the check is disabled, and *Warning, where only a warning is
published (which replaces the high wind warning from the COM_WIND_WARN limit).
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
There is no reason to keep an uncertainty on the origin as it is then
already contained in the local position estimate when GNSS data is fused
in the filter.
The command is sent by a dedicated mavlink command and forwarded to the fixed wing position controller.
The pattern is defined by the radius of the major axis, the radius of the minor axis and the orientation. The pattern is then defined by:
The upper part of the pattern consist of a clockwise circle with radius defined by the minor axis. The center of the circle is defined by the major axis minus the minor axis away from the pattern center.
The lower part of the pattern consist of a counter-clockwise circle with the same definitions as above.
In between, the circles are connected with straight lines in a cross configuration. The lines are always tangetial to the circles.
The orientation rotates the major axis around the NED down axis.
The loitering logic is defined inside its own class used by the fixed wing position control module. It defines which segment (one of the circles or lines) is active and uses the path controller (npfg or l1-control) to determine the desired roll angle.
A feedback mavlink message is send with the executed pattern parameters.
Michał Barciś