Strictly follow the following convention for tailsitter:
FW Attitude and FW rate controller always operate in the FW frame, meaning that roll is
roll in FW, which for tailsitter means around the yaw axis in the body frame. The interfaces
between modules is though always in body frame.
That enables us to do the axis transformations for tailsitter, that are currently distributed
all over the controller (attitude, rate, vtol module), only at the input and output data of modules.
Side effect is that the FW rate control tuning gains meanings change: while before the roll gains
where meant for the body axis, they are now always applied for the FW roll axis (also in hover). So
the naming now is correct for FW, while before it was for Hover.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
This failsafe flag is currently used for not allowing to re-transition to FW, as well
as disabling pusher assist in hover. Till now it was only possible to reset it with
a commanded transition to MC, which many ground station interfaces didn't allow
as the system, after a quad-chute, already was in MC mode.
Hereby it is changed to reset when a new transition to FW is triggered (either via
RC switch or MAVLink command). It is the users responsibility to assess the situation
after a quad-chute happened to try to transition to FW again, manually proceed/land
the vehicle in MC, or let it finish the defined behavior after a quad-chute.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
When we receive a command_long or command_int message to
answer, it arrives with a source sysid/compid, so this means we can send
the command_ack back on the appropriate MAVLink instances instead of all
of them.
This commit filters outgoing command_ack messages, so they are only sent
on the MAVLink instances where the sysid/compid has been seen in the
past.
This means that a command_ack is likely still sent on multiple links for
a setup with redundant links.
This should also prevent command_acks from being blasted on Iridium links
when it's not required.
Signed-off-by: Julian Oes <julian@oes.ch>
* Fixedwing rate control into a separate module
* Start fw_rate_control for vtol
* Move over airspeed related parameters to fw_rate_control
Co-authored-by: Silvan Fuhrer <silvan@auterion.com>
On CubeOrange where no console is configured by default, starting
MAVLink shell just stalls, and doesn't work.
Also, logfile download has been reported not to work, and again, seems
to work with this change.
Signed-off-by: Julian Oes <julian@oes.ch>
- Do not pull in PWM parameters when DISABLE_PARAMS_MODULE_SCOPING is TRUE since VOXL2 has no PWM nor any of the required timer_config files that go along with that
- Replace non-standard M_PI constants with PX4 defined M_PI_F constants
- Include missing header file for function hrt_absolute_time declaration
- Add new PX4_SOC_ARCH_ID for the VOXL2 board
Silvan Fuhrer