In MPC_YAW_MODE 3 (along trajectory), the flight task is asked to
produce a yaw setpoint. If the previous yaw value was NAN (e.g.: during
early takeoff), the setpoint should then be reset to the current
estimate.
It was meant as an example for an easy to use interface of a
motion primitive with a minimal implementation. But the implementation
is much worse than the jerk optimized trajectory. We rather
work on making it easier to use. #18390 was a first step towards that.
- remove GPS failsafe mode
- for VTOL: transition to hover in Descend (unless NAV_FORCE_VT is not set)
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Signed-off-by: RomanBapst <bapstroman@gmail.com>
commander: support orbit mode for fixed wings
Signed-off-by: RomanBapst <bapstroman@gmail.com>
FwPositionControl: publish orbit status
Signed-off-by: RomanBapst <bapstroman@gmail.com>
commander:reject orbit mode while doing a vtol transition
Signed-off-by: RomanBapst <bapstroman@gmail.com>
FixedWingPositionControl: explicitly cast waypoint for Orbit status
FixedwingPositionControl: fill missing orbit_status fields
navigator_main: handle reposition/orbit corner cases
- set orbit rotation direction correctly
- send mavlink message when orbit is rejected
FixedWingPositionControl: correctly report rotation direction in orbit_status
navigator: hack to not break orbit while doing altitude changes
Signed-off-by: RomanBapst <bapstroman@gmail.com>
navigator: set cruise throttle for orbit command
Signed-off-by: RomanBapst <bapstroman@gmail.com>
- use fw pitch setpoint offset during transition
- take over previous vertical velocity and smooth out over transition
Signed-off-by: RomanBapst <bapstroman@gmail.com>
Extract the functionality to plan smooth position motion trajectories into a
motion planning library, such that it can be used in other parts of the code as well.
to get rid of derivative spikes when navigator is
continuously updating the yaw setpoint in the
triplet for a POI but is running at a lower rate.
The proper solution is to generate that yaw setpoint
with high rate in the flight task and have the triplet
just guid to the next waypoint at low rate.
to allow descending by stick for reliable land detection.
Issue:
Stick smoothing gets completely reset to state when not taken off
-> downwards velocity setpoint is gone when not taken off
-> in_descend flag of land detection is never true when not taken off
-> when landing but falling out of landing it landing detection fails
bafore taking off and landing again
Currently only for the Z axis. If the current downward velocity is more
than twice the maximum allowed value, the emergency braking mode is
activated. In this mode, a higher vertical acceleration and jerk is used
until the vehicle stops moving.
Only needed for Makefile-based builds:
gmake[3]: *** No rule to make target 'src/modules/flight_mode_manager/FlightTasks_generated.hpp', needed by 'events/px4.json'. Stop.
Because based on the numerous complaints it was disabled by default
(only velocities above 10m/s were limited)
and since then no one intentionally used it anymore. But
there were some minor investigations of drones not reaching
their maximum speed which always showed 10m/s.
Matthias Grob