Move some logic from Subscriber into uORBManager. This reduces calls from the
modules to the uORB manager, improving performance in protected build.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
- this is a more conservative default if a vehicle isn't set (no land detector running)
- handled horizontal preflight failures in commander when disarmed
rather than overloading xy_valid and v_xy_valid flags
- ekf2 no longer depend on arming or standby status
- ekf2: expose dead reckoning as control status flags
- commander:
- add GPS validity check
- in AUTO MISSION if dependent on GPS then a loss of GPS will
- Also use the delayed current data instead of newest that might not be
available (gps buffer is sometimes empty if the dt between samples is
larger than the delayed horizon).
- Separate "baro fault" from "baro intermittent": intermittent is a
temporary failure and should prevent from switching to baro right now,
but "fault" means that it should never be used anymore
- In case of height timeout, check for metrics but not for consistency
as the filter is likely to have diverged already.
* Adds Timer15 to stm32_common, if the timer base is defined
* Adds Timer15 logic for DMA and AltFunc config on stm32h7 boards
* Adds TIM15 BDTR->MOE support in stm32_common timer init
* Adds support for TIM15 pwm channels on Matek H743 Slim
If the hardware support RESET lockout that has nArmed ANDed with VBUS
vbus_sense may drop during a param save which uses
BOARD_INDICATE_EXTERNAL_LOCKOUT_STATE to prevent external resets
while writing the params. If we are not armed and nARMRED is low
we are in such a lock out so ignore changes on VBUS_SENSE during this
time.
Once we have valid input we should use that and not overwrite our
update_result with the result from other inputs, otherwise the
automatic selection does not actually work.
This behavior means that only the first update will be used if there are
several sources updating in the same cycle.
It was a mistake to mix these two together, it is simpler to implement the boardctl interface
for the protected build, if the boardctl ioctls are different
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
This adds an ioctl interface for NuttX protected build, allowing
system calls from user space to kernel for uORB, HRT and crypto
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
Weak authority on a axis is currently defined as: none of the actuators have an
effectivness on this particular axis larger than 0.05.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
* Navigator: enable DO_CHANGE_SPEED for outside of mission
- update _mission_cruising_speed_mc/_fw also if DO_CHANGE_SPEED command
is received outside of mission (e.g. while Loitering doing an Orbit)
- if vehicle is in AUTO_LOITER when receiving the change speed, then immediately
apply it by doing a reposition without updating any other field than cruising_speed
and cruising_throttle
-when RTL is activated reset the cruising speed and throttle
* Navigator: reset cruise speed and throttle to default when VTOL-transitioning
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
