When requesting a message from a stream that is not active we start the
stream with interval=0 and call the request method once. For all streams
this works fine except the gps_global_origin. For this one the request method
is actually overidden to throttle down the rate and not just send out the message.
This will cause this message to never being sent on request if the stream
is not active by default.
- move EV yaw and EV position to new state machines
- EV yaw and EV pos now configured via EKF2_EV_CTRL (migrated from EKF2_AID_MASK)
- new EV position offset estimator to enable EV position while GPS position is active (no more EV pos delta fusion)
- yaw_align now strictly means north (no more rotate external vision aid mask)
- automatic switching between EV yaw, and yaw align north based on GPS quality
* GPS_RAW_INT: Only send no gps messages if gps has ever been present
* GPS2_RAW: Keep in sync with GPS_RAW_INT
Signed-off-by: Marcell Rausch <marcell@auterion.com>
In review it was requested to have a different name for
manual_control_setpoint.z because of the adjusted range.
I started to investigate what naming is most intuitive and found
that most people recognize the stick axes as roll, pitch, yaw, throttle.
It comes at no surprise because other autopilots
and APIs seem to share this convention.
While changing the code I realized that even within the code base
the axes are usually assigned to a variable with that name or
have comments next to the assignment clarifying the axes
using these names.
- this is a precaution to eliminate the possibility of getting stuck in
a loop trying to keep up with a high rate publication that could be
coming from a higher priority task
- replace float32[21] URT covariances with smaller dedicated position/velocity/orientation variances (the crossterms are unused, awkward, and relatively costly)
- these are easier to casually inspect and more representative of what's actually being used currently and reduces the size of vehicle_odometry_s quite a bit
- ekf2: add new helper to get roll/pitch/yaw covariances
- mavlink: receiver ODOMETRY handle more frame types for both pose (MAV_FRAME_LOCAL_NED, MAV_FRAME_LOCAL_ENU, MAV_FRAME_LOCAL_FRD, MAV_FRAME_LOCAL_FLU) and velocity (MAV_FRAME_LOCAL_NED, MAV_FRAME_LOCAL_ENU, MAV_FRAME_LOCAL_FRD, MAV_FRAME_LOCAL_FLU, MAV_FRAME_BODY_FRD)
- mavlink: delete unused ATT_POS_MOCAP stream (this is just a passthrough)
Co-authored-by: Mathieu Bresciani <brescianimathieu@gmail.com>
- all sources of optical flow publish sensor_optical_flow
- sensor_optical_flow is aggregated by the sensors module, aligned with integrated gyro, and published as vehicle_optical_flow
Co-authored-by: alexklimaj <alex@arkelectron.com>
If we receive gimbal_device_attitude_status by mavlink we should not
re-send it as we are already supposed to be forwarding mavlink traffic
from the gimbal to the ground station.
Silvan Fuhrer