Improve the slow down effect and add support for speed change in mission mode.
Seperate code related to turning setpoints into motor commands into its own folder and refactor code.
- new parameter EKF2_LOG_VERBOSE to enable (currently enabled by default)
- force advertise topics immediately (based on EKF2_LOG_VERBOSE and per aid source configuration)
- logger optionally log all estimator topics at minimal rate
* battery: make time remaining estimation dependent on level flight characteristis for FW
* battery: fix that FW flight is also correctly detected when vehicle_status is not updated
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
* FixedwingPositionControl: Move constant to header file
* flight phase estimation: use tecs height rate reference to check for level flight
---------
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Co-authored-by: Silvan Fuhrer <silvan@auterion.com>
- fake_pos only if at rest or tilt variances becomes large
- fake pos: don't run when grav fusion is enabled
- gravity fusion enabled by default
- gravity: only fuse when accel norm and lpf norm are consistent
Co-authored-by: bresch <brescianimathieu@gmail.com>
- remove deprecated actuator_controls[INDEX_FLAPS/SPOILERS/AIRBRAKES]
- use new topic normalized_unsigned_setpoint.msg (with instances flaps_setpoint
and spoilers_setpoint) to pass into control allocation
- remove flaps/spoiler related fields from attitude_setpoint topic
- CA: add possibility to map flaps/spoilers to any control surface
- move flaps/spoiler pitch trimming to CA (previously called DTRIM_FLAPS/SPOILER)
- move manual flaps/spoiler handling from rate to attitude controller
FW Position controller: change how negative switch readings are intepreted
for flaps/spoilers (considered negative as 0).
VTOL: Rework spoiler publishing in hover
- pushlish spoiler_setpoint.msg in the VTOL module if in hover
- also set spoilers to land configuration if in Descend mode
Allocation: add slew rate limit of 0.5 to flaps/spoilers configuration change
Instead of doing the flaps/spoilers slew rate limiting in the FW Position Controller
(which then only is applied in Auto flight), do it consistently over all flight
modes, so also for manual modes.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- remove deprecated actuator_controls[INDEX_LANDING_GEAR]
- remove dead code in mc rate controller that used to prevent it from being retracted
on the ground (anyway had no effect as it only affected the actuator_control[LANDING_GEAR]
which wasn't sent to the control allocation)
- for VTOLs handle deployment/retraction of landing gear in AUTO as a MC (retract if
more than 2m above ground, deploy if WP is a landing WP), plus additionally when transition
flight task is called (ALTITUDE mode and higher)
- for FW in AUTO: add logic in FW Position Controller, depending on waypoint type mainly
- manual landing gear settings always come through (a manual command overrides a previous
auto command, and vice-versa)
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Tiltrotor_extra_controls also contains collective thrust beside collective tilt, as passing a 3D
thrust setpoint vector beside the tilt is not feasible.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- move EV yaw and EV position to new state machines
- EV yaw and EV pos now configured via EKF2_EV_CTRL (migrated from EKF2_AID_MASK)
- new EV position offset estimator to enable EV position while GPS position is active (no more EV pos delta fusion)
- yaw_align now strictly means north (no more rotate external vision aid mask)
- automatic switching between EV yaw, and yaw align north based on GPS quality
Completely detach the steering wheel logic from the yaw controller (beside using the
same manual stick input in a manual flight mode).
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
