Includes:
- Remove some of the outdated Python2 checks and compatibility.
- Try not catch all exceptions but only the expected ones. Otherwise,
this makes it really hard to debug if anything unexpected actually
goes wrong.
- Make use of fstrings.
- Make output slightly prettier.
Signed-off-by: Julian Oes <julian@oes.ch>
This adds a new protocol extension which allows to get the bootloader
version.
The bootloader version is different from the bootloader protocol
revision which has stabilized at 5 and is not easy to update unless a
bootloader is actually breaking the protocol. The reason being that both
the Python script as well as the uploader used in QGC will not attempt
to load firmware if they don't know the bootloader version, so it could
basically be considered a "breaking" protocol revision.
Signed-off-by: Julian Oes <julian@oes.ch>
If the STM32H7 fails to program or erase a full chunk of 256 bytes, the
ECC check will trigger a busfault when trying to read from it.
To speed up erasing and optimize wear, we read before erasing to check
if it actually needs erasing. That's when a busfault happens and the
erase time outs.
The workaround is to add an option to do a full erase without check.
Credit goes to:
https://github.com/ArduPilot/ardupilot/pull/22090
And the protocol option added to the bootloader is the same as for
ArduPilot, so compatible.
Signed-off-by: Julian Oes <julian@oes.ch>
* usb: Added parameter to enable always starting mavlink on USB.
Refactored cdcacm_init into a module and added a paramter to allow always starting mavlink on
USB, also added a paramter to choose the mode. The current default behavior is to wait and listen
for data on USB and auto-detect the protocol (mavlink, nsh, ublox). This results in the mavlink
stream not starting until something else on the mavlink network sends a packet first. The new
default behavior is to always start mavlink.
Added parameters
MAV_USB_ENABLE -- default 1 (always start mavlink on USB)
MAV_USE_MODE -- default 3 (onboard)
* added 3 retries for opening serial port in mavlink, removed sleep before sercon
* added DRIVERS_CDCACM_AUTOSTART to ark-v6x default.px4board
* added CONFIG_DRIVERS_CDCACM_AUTOSTART=y to default.px4board for boards with CONFIG_CDCACM in their nsh/defconfig
* format
* remove PGA460 from COMMON_DISTANCE_SENSOR to save flash
* remove LIS2MDL from COMMON_MAGNETOMETER to save flash
* disable CONFIG_DRIVERS_CDCACM_AUTOSTART for fmu-v5 protected.px4board
* moved and renamed parameters, removed mode logic in mavlink
* changed parameter names, added mode none
* remove parameters from mavlink
- increase symforce CppConfig zero_initialization_sparsity_threshold so
that a Matrix setZero() call is performed instead of individually zeroing
Co-authored-by: bresch <brescianimathieu@gmail.com>
The setting wasn't consistent with the one used in the Visual Studio
Code settings, which caused different newline formatting depending on
whether the user uses Visual Studio Code or another editor that uses
EditorConfig.
This notes the reference yaw angle for the Septentrio Mosaic-H.
It's unfortunately a bit tricky in that Unicore has the main antenna
in front by default while Septentrio decided to put the aux antenna in
front.
Signed-off-by: Julian Oes <julian@oes.ch>
Regression from https://github.com/PX4/PX4-Autopilot/pull/23043
Also avoids a race condition by making sure the command ack is handled
before sending out the mavlink message (in case an external component
reacts immediately to the mavlink message).
Beat Küng