- ekf2: expose dead reckoning as control status flags
- commander:
- add GPS validity check
- in AUTO MISSION if dependent on GPS then a loss of GPS will
- Also use the delayed current data instead of newest that might not be
available (gps buffer is sometimes empty if the dt between samples is
larger than the delayed horizon).
- Separate "baro fault" from "baro intermittent": intermittent is a
temporary failure and should prevent from switching to baro right now,
but "fault" means that it should never be used anymore
- In case of height timeout, check for metrics but not for consistency
as the filter is likely to have diverged already.
Once we have valid input we should use that and not overwrite our
update_result with the result from other inputs, otherwise the
automatic selection does not actually work.
This behavior means that only the first update will be used if there are
several sources updating in the same cycle.
Weak authority on a axis is currently defined as: none of the actuators have an
effectivness on this particular axis larger than 0.05.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
* Navigator: enable DO_CHANGE_SPEED for outside of mission
- update _mission_cruising_speed_mc/_fw also if DO_CHANGE_SPEED command
is received outside of mission (e.g. while Loitering doing an Orbit)
- if vehicle is in AUTO_LOITER when receiving the change speed, then immediately
apply it by doing a reposition without updating any other field than cruising_speed
and cruising_throttle
-when RTL is activated reset the cruising speed and throttle
* Navigator: reset cruise speed and throttle to default when VTOL-transitioning
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
-pass flag EffectivenessUpdateReason into effectiveness, indicating if there was an external
update or not. Reasons for external updates are:
-config changes (parameter)
-motor failure detected or certain redundant motors are switched off to save energy
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- mavlink in PX4/Firmware (9457e7b25c4fa51f5ccc0bd887760e910926ba8a): 311eee010b
- mavlink current upstream: 4b0558d0d1
- Changes: 311eee010b...4b0558d0d1
4b0558d0 2022-02-11 Andrew Tridgell - added CANFD_FRAME and CAN_FILTER_MODIFY messages
7f032afe 2022-02-10 Daniel Agar - Apply suggestions from code review
9379a601 2022-02-06 Andrew Tridgell - common: added MAV_CMD_CAN_FORWARD and CAN_FRAME
