- vectornav library (libvnc) fixed for NuttX
- open serial port O_NONBLOCK (like __APPLE__)
- set serial port baud rate with cfsetspeed (like __APPLE__)
- vectornav backend thread increase stack and run at higher priority (SCHED_FIFO)
Block Device driver uses a buffer so we need to ensure data is written or read to the device and not to the buffer so we can be sure if the device works properly
* Cyphal: fix comparing floating-point issue
* Cyphal: fix setpoint serialization
* Cyphal: fix bug with wrong comparasion of param name and pub/sub name: remove prefix from UavcanPublisher::updateParam and UavcanDynamicPortSubscriber::updateParam and PublicationManager::updateDynamicPublications
* Cyphal: integrate UavcanEscController with PublicationManager, remove second instance of UavcanEscController from CyphalNode
* Cyphal: publish readiness with minimal frequency because according to UDRAL The drive shall enter STANDBY state automatically if the readiness subject is not updated for CONTROL_TIMEOUT
* Cyphal: increase setpoint publish rate from ~75 to 200 by removing PX4_INFO (it really significantly react on the the output rate) and changing the mixing output rate and the shedule interval
* Cyphal: restore prefix because we need it for uorb over uavcan/cyphal and add udral prefix for non uorb pub/sub
* Cyphal: fix DynamicPortSubscriber subscription: if it has multiple subscribers, it should call subscription only after updating of all port subscribers port identifiers
* Cyphal: fix SubscriptionManager: we should take care about prefix
* Cyphal: fix readiness for test motor mode
* [Cyphal] Fix dynamicsubscription, improve printinfo, enable MR-CANHUBK3 config
---------
Co-authored-by: Peter van der Perk <peter.vanderperk@nxp.com>
- pass new airspeed sample around when available
- can't completely eliminate _airspeed_sample_delayed until resetWind()
called from sideslip fusion is updated
- reduce boost priority to PX4_WQ_HP_BASE - 6
- add cli command 'trigger_watchdog' to manually trigger watchdog
- add perf counters when triggering watchdog
- reduce top measurement to 300ms
- restore priorities after 1.5s
There are precautions in case the SD card code itself has a busy-loop.
Enable automatic landing abort on timed out distance sensor reading also for
the circular landing. Do not enable the no-terrain timeout check, as, opposed
to the straight landing, we here don't know when to expect the distance sensor
to get valid.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
