* Enable motor controls for fixed wing mode in tailsitters
This commit enable motor controls in fixed wing mode for tailsitters
This is needed for enabling quad tailsitters
* VTOL: differential thrust in FW: adapt params to be generic for all axes
Until now only suppoted on yaw axis. Not to be supported also on Roll and Pitch.
- VT_FW_DIFTHR_EN: make bitmask for all three axes independently. First bit is Yaw,
sucht that existing meaning of VT_FW_DIFTHR_EN doesn't change.
- VT_FW_DIFTHR_SC: rename to VT_FW_DIFTHR_S_Y and add same params for roll (_R) and
pitch (_P).
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
* Integrate differential control bits to three axis control
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
* vtol_type: only allow positive pitch setpoints during backtransition
* vtol params: set default of VT_B_DEC_FF to 0, as for most frames a FF is not necessary
* Tiltrotor: fix throttle during first part of back transition
* Tiltrotor: only enable all motors in second phase of backtransition (tilting phase)
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
The device path is needed to apply PWM limits on the motors that are not
used for FW flight (switch them off). With this parameter the device path can be set
to either IO or FMU, depending on whether the motors are on the IO or FMU port.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- VT_MOT_COUNT assumed that motors were always the first outputs. This
does not have to be true always. VT_MOT_ID allows to specify precisely how
many motors we have for hovering and to which channel they are connected.
Signed-off-by: RomanBapst <bapstroman@gmail.com>
* VTOL trans: changed that now in transition for both MC and FW the corresponding (correct) attitude controller is running
* attitude setpoint for stabilized mode is generated by tailsitter.cpp
* reset yaw setpoint during transition to avoid big yaw errors after
transition back to hover
* VT_TYPE parameter: added "reboot required" metadata
Mark V19_VT_ROLLDIR @category system
Throttle down mavlink critical msg
Send 0 actuator_output for safety
VTOL: unset v1.9 roll direction safety check param for builtin airframes
* attitude and rate setpoint message: use 3D array for thrust demand
* FixedWingAttitudeControl: rework airspeed scaling
* move airspeed and scaling calculation into separate method
* if vtol in hover and airspeed disabled use minimum airspeed instead of trim airspeed
- moved methods used to modify channel maximum pwm value to VtolType
class so that the can be shared by the differnt vtol types
Signed-off-by: Roman <bapstroman@gmail.com>
- standard vtol was implementing many custom parameters although they
are generic and should be shared between the vtol types
- removed heavy usage of hrt_elapsed_time() which is a system call and
could be computationally expensive
* FW actuators fully on the entirety of front and back transition
* back transition ramp up to full MC weight half way through back transition
* increase maximum front and back transition times
* navigator don't reset transition altitude
- weathervane on takeoff
- separate cruising speeds for VTOL in MC and FW
- cruising speed resets
- mission work item logic is more clear
- fixed double execution of certain work item states
- enable cruise speed change on the fly by command
- moved VTOL transition target position generation to mission code and set always
Silvan Fuhrer