- uses the FIFO and SPI DMA to transfer full raw data (8 kHz gyro, 4 kHz accel)
- new sensor messages for better visibility
- sensor_{accel, gyro}_fifo: full raw data for optional logging and analysis
- sensor_{accel, gyro}_status: metadata, clipping, etc
- currently not enabled by default
As a convenience we send down the amount of do jumps left to do.
However, we should not send the mission item if happen to be in the
middle of another transfer.
This fixes the warning:
Mission storage: Unable to read from microSD
which appeared on do jump mission items. The reason was that the
_mission_type can be set to rally or geofence if that was the last
transfer which had happened earlier. Therefore, it would then try to
read a certain rally item from dataman when really a mission item was
supposed to be read.
Currently actuator offboard control interferes with SITL lockstep.
Therefore, the least we can do is to warn a user and inform them how to
workaround the issue.
and remove the px4_ prefix, except for px4_config.h.
command to update includes:
for k in app.h atomic.h cli.h console_buffer.h defines.h getopt.h i2c.h init.h log.h micro_hal.h module.h module_params.h param.h param_macros.h posix.h sem.h sem.hpp shmem.h shutdown.h tasks.h time.h workqueue.h; do for i in $(grep -rl 'include <px4_'$k src platforms boards); do sed -i 's/#include <px4_'$k'/#include <px4_platform_common\/'$k/ $i; done; done
for in $(grep -rl 'include <px4_config.h' src platforms boards); do sed -i 's/#include <px4_config.h/#include <px4_platform_common\/px4_config.h'/ $i; done
Transitional headers for submodules are added (px4_{defines,log,time}.h)
I don't understand why we should wait to parse incoming MAVLink traffic
just because we don't have the source address initialized. We still
check the source address before doing a sendto.
This should fix serial MAVLink communication on FMU5x where both serial
and UDP is available. There the serial connection previously did not
work because nothing was connected over UDP.
Without lockstep the actual monotonic clock of the host computer is
used. Therefore, this time is likely much more than 20 seconds and the
check if the boot complete happened in time will fail immediately.
Therefore, it probably makes more sense to count the time from the first
mavlink creation.
This was added to enable a Pixhawk to be used as an RC input for e.g.
SITL. As far as we're aware of that's not really used. However, sending
this can cause issues if multiple Pixhawks are in the same network.
Also, is uses up some of the MAVLink bandwidth.
Therefore, it's probably best to remove that feature for now.
Beat Küng