- remove GPS failsafe mode
- for VTOL: transition to hover in Descend (unless NAV_FORCE_VT is not set)
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- bit of clean up
- add GPS failsafe mode auto_altitude, that will keep current altitude with a fixed-bank angle
for some time, then switches to auto_descend that will descend with constant sink rate
of 0.5m/s
- params controlling GPS failsafe are not FW params: NAV_GPSF_R --> FW_GPSF_R and
NAV_GPSF_LT --> FW_GPSF_LT
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Unwraps the set_loiter_item() to solve the issue where the altitdue setpoint
in a MC takeoff wasn't correctly used.
Signed-off-by: RomanBapst <bapstroman@gmail.com>
This PR changes the COM_ARM_MAG_STR parameter to accept values. If the parameter is set to 2, the check is performed and a warning is logged but the vehicle can still arm.
an airpseed of > 2m/s is required to start the fusion (set by param)
fw mode is also required
Given the larger estimated windspeed after those changes, the change of
static pressure is larger and the height estimate takes more time to
reach the final value
Signed-off-by: RomanBapst <bapstroman@gmail.com>
commander: support orbit mode for fixed wings
Signed-off-by: RomanBapst <bapstroman@gmail.com>
FwPositionControl: publish orbit status
Signed-off-by: RomanBapst <bapstroman@gmail.com>
commander:reject orbit mode while doing a vtol transition
Signed-off-by: RomanBapst <bapstroman@gmail.com>
FixedWingPositionControl: explicitly cast waypoint for Orbit status
FixedwingPositionControl: fill missing orbit_status fields
navigator_main: handle reposition/orbit corner cases
- set orbit rotation direction correctly
- send mavlink message when orbit is rejected
FixedWingPositionControl: correctly report rotation direction in orbit_status
navigator: hack to not break orbit while doing altitude changes
Signed-off-by: RomanBapst <bapstroman@gmail.com>
navigator: set cruise throttle for orbit command
Signed-off-by: RomanBapst <bapstroman@gmail.com>
The situation where this would be desired is unclear, plus it's basically
the same as setting ASPD_SC_P_NOISE to a very small value.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Do no longer use tas_innovation from wind estimator and test ratio, but calculate
the innovation based on wind estimate, TAS measurement (including currently applied scale)
and ground velocity. Use innovations directly to trigger failure.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
