- new static notch filter configured via IMU_GYRO_NF1_FRQ and IMU_GYRO_NF1_BW
- existing notch parameters IMU_GYRO_NF_FREQ and IMU_GYRO_NF_BW become
IMU_GYRO_NF0_FRQ and IMU_GYRO_NF0_BW
- bit of clean up
- add GPS failsafe mode auto_altitude, that will keep current altitude with a fixed-bank angle
for some time, then switches to auto_descend that will descend with constant sink rate
of 0.5m/s
- params controlling GPS failsafe are not FW params: NAV_GPSF_R --> FW_GPSF_R and
NAV_GPSF_LT --> FW_GPSF_LT
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- new sensors work item that subscribes to N x sensor_gps and publishes vehicle_gps_position
- blending is now configurable with SENS_GPS_MASK and SENS_GPS_TAU
Co-authored-by: Jacob Crabill <jacob@volans-i.com>
Co-authored-by: Jacob Dahl <dahl.jakejacob@gmail.com>
Before #14212 the velocity control gains used in the multicopter
position controller were defined as a scale between velocity error in
one axis (or it's integral and derivative respectively) and the unit
thrust vector. The problem with this is that the normalization of the
unit thrust vector changes per vehicle or even vehicle configuration
as 0 and 100% thrust get a different physical response. That's why
the gains are now defined as scale between velocity error
(integral/derivative) and the output acceleration in m/s².
* fix param import transition for MC_DTERM_CUTOFF
The previous implementation did not work, as there was a check for
param_find_no_notification() returning PARAM_INVALID for IMU_DGYRO_CUTOFF,
and therefore would not call param_modify_on_import().
This moves param_modify_on_import() before the check and makes it modify
the bson node directly.
* parameters: fix param import transition when testing is enabled
BUILD_TESTING is used for unit test builds, PX4_TESTING is used to enable additional test material within PX4
Co-authored-by: Daniel Agar <daniel@agar.ca>
- interupt pin set active low and latch
- relax retry timeout if configure failed
- improve configured empty rate (sample rate) rounding
- fix RegisterCheck
- check FIFO count as part of full transfer and reset or adjust timing if necessary
- rename DRV_IMU_DEVTYPE_ICM20608 -> DRV_IMU_DEVTYPE_ICM20608G
This avoids the need for recalibration, and also cleans up other driver
ID's (merge separate accel/gyro).
The SPI address was previously set to a board-specific (arbitrary) value,
and is now set to 0. This will allow extending for multiple sensors of the
same type on the same bus.
