- split out switches from manual_control_setpoint into new message manual_control_switches
- manual_control_switches published at minimal rate (~ 1 Hz) or immediately on change
- simple switch debounce in rc_update (2 consecutive identical decodes required)
- manual_control_switches logged at full rate rather than sampled at (5-10% of messages logged)
- manual_control_setpoint publish at minimal rate unless changing
- commander handle landing gear switch for manual modes
- processing of mode_slot and mode_switch is now split so we only do one or the other (not both)
- a future step will be to finally drop mode_switch and accompanying switches entirely
Co-authored-by: Matthias Grob <maetugr@gmail.com>
If the first publisher publishes multiple commands right after each other
(e.g. on 'commander takeoff'), mavlink would miss the first and print an
error like 'vehicle_command lost, generation 0 -> 2'.
This is due to a recent uORB behavior change.
The message GPS_GLOBAL_ORIGIN is meant as a telemtry information message
to send out the components reference and not to set it. I had to switch
to listen to SET_GPS_GLOBAL_ORIGIN such that I can implement sending out
GPS_GLOBAL_ORIGIN.
- Note the TX buffer size check is lazily ignoring the possibility of messages that span multiple Mavlink STATUSTEXT. This at least accommodates the calibration use case and it's no worse than before for longer messages.
- ekf2 can now run in multi-instance mode (currently up to 9 instances)
- in multi mode all estimates are published to alternate topics (eg estimator_attitude instead of vehicle_attitude)
- new ekf2 selector runs in multi-instance mode to monitor and compare all instances, selecting a primary (eg N x estimator_attitude => vehicle_attitude)
- sensors module accel & gyro inconsistency checks are now relative to the mean of all instances, rather than the current primary (when active ekf2 selector is responsible for choosing primary accel & gyro)
- existing consumers of estimator_status must check estimator_selector_status to select current primary instance status
- ekf2 single instance mode is still fully supported and the default
Co-authored-by: Paul Riseborough <gncsolns@gmail.com>
- mavlink messages DEBUG/DEBUG_FLOAT_ARRAY/DEBUG_VECT/NAMED_VALUE_FLOAT move to separate stream headers and don't include if CONSTRAINED_FLASH
- mavlink receiver DEBUG/DEBUG_FLOAT_ARRAY/DEBUG_VECT/NAMED_VALUE_FLOAT handling excluded if CONSTRAINED_FLASH
- msg: skip debug_array.msg, debug_key_value.msg, debug_value.msg, debug_vect.msg if CONSTRAINED_FLASH
Daniel Agar