Channel values stay over one unit test but some tests assumed they are
reset each time. Reset the channel after these mode button tests.
Parameters survive between unit tests presumably as long as
the bianry runs. Reset them if a test requires that.
This allows PWM and all other output methods to configure
stopped, idling and full thrust points and use them consistently.
The fact that a fixed wing motor can be stopped when zero thrust
is demanded is explicit and could in principle even be disabled.
The mechanism is the same as for a standard VTOL stopping the
multicopter motors in the fixed wing flight phase.
This allows to consistently define:
Motor stopped - disarmed PWM
Motor idling - minimum PWM
Motor at full thrust - maximum PWM
Any allocation can then distinctly decide if
a motor should be running or not depending
on the context and also explicitly command that.
This is required to process data from the ADS1115 ADC and enables the
params BATx_I_CHANNEL and BATx_V_CHANNEL.
Testing is required whether this actually works on Pixhawk 6X though.
Signed-off-by: Julian Oes <julian@oes.ch>
When switching into Hold mode establish a Loiter around current position,
even if we were before already loitering (eg in Mission mode).
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Having newline between I think didn't apply the PR stale days setting of
30 properly (it was using 45)
And it seemd that unless I set the days-before-close to -1
intentionally, it would still close the Issue/PRs, as the default value
is 7 already.
Also updated version of the stale action to v8
* Remove old stale bot yaml file
* Remove slack svg file (unused)
* Stale action: Only apply stale label, and no other actions
Respecting the opinion on
https://github.com/PX4/PX4-Autopilot/commit/fa9ac6ecf651232f3105ca124a2d2c54ab8620d0,
it seems reasonable to disable commenting feature, and just keep the
action only applying the `stale` label. This will reduce the noise /
email spams / ping pong fight with the stale bot (Action)
- Remove unnecessary text rendering, which made clicking log links
harder
- Re adjust markdown elements to make it easier to read / intuitive when
creating an issue
Instead of hard-coding the tilting duration (from FW to MC tilt),
expose it as a parameter (VT_BT_TILT_DUR). The default is the same
as the hard-coded value previously (1s).
Slower tilting mechanisms need a higher value here, while for smaller
ones a too high value results in unnecessary delays till the motors
are in hover configuration.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
This affects how soon after a backtransition the vehicle has the
full hover controller running again. Specifically it reduces the
duration of the ramp down of the motors prior to tilting them.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Matthias Grob