* add standard vtol airframe to SIH.
mostly took changes from 4d930bde and applied to main.
generate_fw_aerodynamics now takes four arguments rather than using the
_u class member, because depending on vehicle type _u is used
differently.
MIS_LTRMIN_ALt was used to limit the go-to altitude of a LOITER_TO_ALT (not the exit altitude,
but the altitude that the vehicle went to to fly to WP), and during landing abort to climb to
at least this altitude. The min entry altitude of LOITER_TO_ALT I remove with this commit, while
for the min alt during abort I added the new parameter MIS_LND_ABRT_ALT.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
I think most vehicle can safely decend with at least 1.5m/s, and having this
value too low makes Descents/Landings/RTLs unnecessary long.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Without this, uavcan creates MixingOutput classes which then create
empty actuator_outputs publications. This then prevents the motor
output in HITL to be forwarded to the simulator via mavlink.
- set MAV_TYPE as a parameter default per vehicle type, or airframe if necessary
- cleanup MAV_TYPE param metadata and commander helper to only include
what's currently used in PX4
Remove params from airframe configs that are just set again
to the param default value or to the value that is
specified in the mc_default, fw_default or vtol_default.
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
Using mixers on the IO side had a remote benefit of being able to
override all control surfaces with a radio remote on a fixed wing.
This ended up not being used that much and since the original design
10 years ago (2011) we have been able to convince ourselves that the
overall system stability is at a level where this marginal benefit,
which is not present on multicopters, is not worth the hazzle.
Co-authored-by: Beat Küng <beat-kueng@gmx.net>
Co-authored-by: Daniel Agar <daniel@agar.ca>
Before #14212 the velocity control gains used in the multicopter
position controller were defined as a scale between velocity error in
one axis (or it's integral and derivative respectively) and the unit
thrust vector. The problem with this is that the normalization of the
unit thrust vector changes per vehicle or even vehicle configuration
as 0 and 100% thrust get a different physical response. That's why
the gains are now defined as scale between velocity error
(integral/derivative) and the output acceleration in m/s².
Mark V19_VT_ROLLDIR @category system
Throttle down mavlink critical msg
Send 0 actuator_output for safety
VTOL: unset v1.9 roll direction safety check param for builtin airframes
Balduin