This is a combination of the originally introduced delay:
06c10f61c1
then the emergency failsafe being changed to not just land,
position control being rescheduled to not overwrite every setpoint in:
e502214429576ce68ac3fee9d2db19112f4604b9
and it being fixed by overwriting the setpoint but not removing
the long obsolete hystersis here:
114e85d260
Because based on the numerous complaints it was disabled by default
(only velocities above 10m/s were limited)
and since then no one intentionally used it anymore. But
there were some minor investigations of drones not reaching
their maximum speed which always showed 10m/s.
- parameter updates can be quite expensive because they trigger nearly all modules to reload all of their parameters immediately
- limit modules from updating faster than once per second
- split out switches from manual_control_setpoint into new message manual_control_switches
- manual_control_switches published at minimal rate (~ 1 Hz) or immediately on change
- simple switch debounce in rc_update (2 consecutive identical decodes required)
- manual_control_switches logged at full rate rather than sampled at (5-10% of messages logged)
- manual_control_setpoint publish at minimal rate unless changing
- commander handle landing gear switch for manual modes
- processing of mode_slot and mode_switch is now split so we only do one or the other (not both)
- a future step will be to finally drop mode_switch and accompanying switches entirely
Co-authored-by: Matthias Grob <maetugr@gmail.com>
bresch