- split out integrated data into new standalone messages (sensor_accel_integrated and sensor_gyro_integrated)
- publish sensor_gyro at full rate and remove sensor_gyro_control
- limit sensor status publications to 10 Hz
- remove unused accel/gyro raw ADC fields
- add device IDs to sensor_bias and sensor_correction
- vehicle_angular_velocity/vehicle_acceleration: check device ids before using bias and corrections
* Mavlink: subscribe to airspeed_validated instead of airspeed topic
This e.g. changes the way QGC displays the airspeed in case of an
airspeed failure (0 instead of the last valid airspeed). It will
always display the airspeed that's used currently in the control
modules.
* FW land detector: move to subscribe to airspeed_validated instead of airspeed topic
- the land detector checks further if the airspeed is NAN, in which case
it sets the airspeed to 0 (min groundspeed, vz and accel checks still
have to pass.
* Fixed-wing land detector use airspeed_vaidated: addressed review comments
- replaced ternary by conditional
- set airspeed to 0 if airspeed_validated stops publishing
Signed-off-by: Silvan Fuhrer <silvan@auterion.com>
- uses the FIFO and SPI DMA to transfer full raw data (8 kHz gyro, 4 kHz accel)
- new sensor messages for better visibility
- sensor_{accel, gyro}_fifo: full raw data for optional logging and analysis
- sensor_{accel, gyro}_status: metadata, clipping, etc
- currently not enabled by default
and remove the px4_ prefix, except for px4_config.h.
command to update includes:
for k in app.h atomic.h cli.h console_buffer.h defines.h getopt.h i2c.h init.h log.h micro_hal.h module.h module_params.h param.h param_macros.h posix.h sem.h sem.hpp shmem.h shutdown.h tasks.h time.h workqueue.h; do for i in $(grep -rl 'include <px4_'$k src platforms boards); do sed -i 's/#include <px4_'$k'/#include <px4_platform_common\/'$k/ $i; done; done
for in $(grep -rl 'include <px4_config.h' src platforms boards); do sed -i 's/#include <px4_config.h/#include <px4_platform_common\/px4_config.h'/ $i; done
Transitional headers for submodules are added (px4_{defines,log,time}.h)
This was added to enable a Pixhawk to be used as an RC input for e.g.
SITL. As far as we're aware of that's not really used. However, sending
this can cause issues if multiple Pixhawks are in the same network.
Also, is uses up some of the MAVLink bandwidth.
Therefore, it's probably best to remove that feature for now.
* attitude and rate setpoint message: use 3D array for thrust demand
* FixedWingAttitudeControl: rework airspeed scaling
* move airspeed and scaling calculation into separate method
* if vtol in hover and airspeed disabled use minimum airspeed instead of trim airspeed
Daniel Agar