MavLink spec implementation
implemented vehicle_roi topic
rename old gimbal to rc_gimbal
little changes
corrected RC Gimbal group
Starting ROI implementation in commander
implementation done, needs to be tested
uhm..
add todo
Change to float32 for x,y and z
remove mission topic again, not needed
change roi coordinates to lat, lon and alt
adjust to float64
starting mount implementation
correcting small mistakes, compiles now
add todos
further progress
implementing parameters
adjust default parameters
started implementation of mavlink
fix typo
change to lat, lon and alt
fix typo :D
change to double (to represent float64)
add global_position_
add mount topic
commander mount implementation done
cleanup
almost finished
little fix
codestyle fixes
leave pitch at 0 degrees
added pitch calculation
codestyle changes
Undo vehicle_mount, react to updated parameters, parsing of CMD_DO_MOUNT_* in mount.cpp
start implementing mode override
forgot a semikolon.
add debug
Finish implementation of mount override and manual control.
fix codestyle
correct cleanup
rename to vmount
works now
fix rebase error
fix polling
refactoring and custom airframe for gimbal
couple changes
remove warnx
almost done
finally
What is going on?
change back to actuator_controls_2
working
bump parameter version number and some clarification
fix submodules
- voting is now at a central place instead of duplicated within the
estimators
-> this also means that estimators that did not do voting so far,
now have voting, like ekf2
- estimators requiring more than that can still subscribe to the raw
sensors
- allows sensors_combined to be 3 times smaller
- reduces logger, memcpy (cache) & RAM overhead
- all modules requiring only 1 or 2 sensor values now automatically get
the voted result
- this also adds voting to baro
The param COM_ARM_WO_GPS is set to 1 by default to allow arming without
GPS. This then sets a bool arm_without_gps which translates to
!GNSS_check in preflightCheck.
The deleted code conflicts with the failsafe handling in set_nav_state.
Also, flight termination was usually disabled by circuit breaker which
means this code had no effect anyway.
The param NAV_RCL_ACT was not implemented as described. Also, it has the
completely the wrong name. It should be a COM param and not NAV.
Therefore, remove the param and delete the partly implemented
and probably never used functionality.
