* usb: Added parameter to enable always starting mavlink on USB.
Refactored cdcacm_init into a module and added a paramter to allow always starting mavlink on
USB, also added a paramter to choose the mode. The current default behavior is to wait and listen
for data on USB and auto-detect the protocol (mavlink, nsh, ublox). This results in the mavlink
stream not starting until something else on the mavlink network sends a packet first. The new
default behavior is to always start mavlink.
Added parameters
MAV_USB_ENABLE -- default 1 (always start mavlink on USB)
MAV_USE_MODE -- default 3 (onboard)
* added 3 retries for opening serial port in mavlink, removed sleep before sercon
* added DRIVERS_CDCACM_AUTOSTART to ark-v6x default.px4board
* added CONFIG_DRIVERS_CDCACM_AUTOSTART=y to default.px4board for boards with CONFIG_CDCACM in their nsh/defconfig
* format
* remove PGA460 from COMMON_DISTANCE_SENSOR to save flash
* remove LIS2MDL from COMMON_MAGNETOMETER to save flash
* disable CONFIG_DRIVERS_CDCACM_AUTOSTART for fmu-v5 protected.px4board
* moved and renamed parameters, removed mode logic in mavlink
* changed parameter names, added mode none
* remove parameters from mavlink
* Added decoy termios support to Qurt so that ghst parser in RC library can be used. No termios is actually needed but has to be there for the parser to work
- Added offset to Posix hrt time to account for synchronization with Qurt hrt time
- Added new Kconfig to configure synchronization of HRT timestamps on VOXL2
- Moved voxl2 libfc sensor library submodule from muorb module to boards directory
- Added check to make sure hrt_elapsed_time can never be negative
The voxl2 has a split architecture. PX4 runs on a posix platform and a Qurt platform. The two communicate uorb topics back and forth with the muorb module. But each has it's own parameters database and they need to stay in sync with each other. This PR adds support to keep the 2 parameter databases in sync. The main parameters database running on Linux has file system support while the Qurt one does not. The Linux side is considered the primary and the Qurt side is considered the remote.
This prevents accidental misconfiguration via I2C if there are
multiple SPI devices on the same bus. The device may hear it's i2c address
and write some register, while there is data transfer ongoing with another
device.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
* Removed obsolete voxl2-io directory
* Updated support for ModalAI FC v2 board
* Added UAVCAN back in and removed local position estimator and attitude estimator Q that are no longer supported.
* Removed unneeded IMU drivers
Julian Oes